Sport & Outdoor – Others

Experienced athletes share their insights in answering this question:
This video is as good as anything although I wouldn’t pitch it on a hill! These are written instructions;

Start by stretching out the bottom of the tent into a square, and stake all of the perimeter tentloops to the ground, starting with the corners, with the stakes directed at a 30 to 45 degree angle under the tent, so the tent cannot easily pull them back out. Leave the yellow cords attached to the tentloops loose, so you can use the cords to help pull up the stakes when you take down the tent.

Now assemble the poles going through the loops across the front of the screen porch. Insert one end of a pole #1 into a pole #2 and thread them through the loops over the entrance to the screen porch. Put the long end of a curved pole #3 through the loops starting from one side, and attach to either side of the 1/#2 you made. Put the long end of another #3 through the loops starting from the other side and attach to the loose end of the #1/#2. You should tie the loose green cords on each corner of the sceen porch to the silver metal rings at the curved end of each #3.
Later, you will do the exact same assembly with a #3 on each side of a #1/#2 for the poles going across the back of the tent and the poles going through the pocket across the middle/top of the tent.

Now insert the small end of pole #4 into the curved end of a #3, then insert the small end of a #5 into the open end of the #4. There should be a rubber foot on the bottom of the #5 pole. Do the same thing for the other side of the porch. With help, you should be able to prop up the front of the sceen porch, pulling aganst the stakes holding the rear floor of the tent, and place the rubber feet of the #5 poles close to the center loops of the floor on each side.

Now prepare the #1/#2 poles for the rear, and attach a #3 to each side and tie the loose green cords to the silver rings on the short ends of the #3s. Prepare a #4/#5 pole the same as the front, and prop up the back of the tent, putting the feet near the side loops of the floor which are about 1/3 from the rear of the tent.

Make another #1/#2/#3, and push it through the pocket across the middle of the tent, and connect the last #3 from the other side. The side supports for the middle are pole #8 with the white clamp on the bottom, and pole #7 slid into pole #8 (The #7 was scraped off both of mine). Leave the #7 mostly inserted into the #8 until after the center is lifted up. The #6 goes on top of #7, and insert the #6 into the curved end of the #3 poles which are already in the center pocket, and tie the loose green cords to the silver rings at the short end on each of the #3s. Now lift up the center with someone helping on the other side, and put the feet of the #8 into or near the yellow loops at the center of each side. Loosen the white clamps and extend the #7 poles until the peak of the tent is at proper height.
Move the feet of the #5 poles closer to the tent, until all is tight, and you should be done!

Setting up Northwest Territory Front Porch Tent

How to Identify and Resolve Common Issues ?

We offer a diverse range of insights on identifying and resolving common problems in sports. Our sources encompass academic articles, blog posts, and personal essays shared by seasoned athletes. :

The parts of a tent include the tent body, vents, tent poles, a rainfly, vestibules, bug netting/mesh, groundsheets, tent pegs (stakes), guy lines, tie out points, storage pockets (gear lofts), tent footprints, etc. Each part plays an equally important part in the construction of your tent.
Even though dome tents look difficult to set up alone, they are actually one of the easiest tents to assemble by yourself! If you have a newer dome tent, it is simpler than ever to put one together. However, a lost instruction manual can mean the difference between an easy task and a much more difficult one.
How to Put Up a Camping Tent Inside a Bedroom
  1. Make space for the tent. If necessary, move some furniture and pick up toys. …
  2. Set down two or three layers of blankets for padding.
  3. Lay the tent on the floor, centered over the blankets. …
  4. Put the support poles together. …
  5. Tip.
However, almost all tents can be grouped into 1 of 4 categories based on their shape. Here are the 4 different types of tents: A-Frame tents, Pyramid tents, Hoop tents, and Dome tents.
With the average tent being the equivalent of 8,750 plastic straws, it`s always worth repairing your tent when possible. And it`s cheaper. A decent quality tent should last for years if you look after it, and that doesn`t mean it has to be an expensive branded tent either.
Patching Holes in Your Tent

Sharp sticks, stones and errant tree branches can sometimes rip your tent`s fabric. If you carry a patch kit with you while camping or backpacking, you can repair a tear in a tent`s wall, mesh or rainfly while you`re out there. Or you can wait to do it at home.

Discover Relevant Questions and Answers for Your Specific Issue

the most relevant questions and answers related to your specific issue

Centre pole is failing to hold tent up in any real wind
ANSWER : TRY DRILLING A SMALL HOLE ON THE INNER POLE SLIGHTLY SMALLER THAN THE DIAMETER OF THE SCREW. U WILL WANT TO DRILL SMALL HOELS EVERY FEW INCHES(CM) SO THAT U WILL BE ABLE TO SET THE POLE AT VARIOUS HEIGHTS IN THE FUTURE.

Read Full Q/A … : Sport & Outdoor – Others

I need new poles for Swiss Gear tent # SG33071F
ANSWER : Go to Home depot and buy a tube that fit the pole. Cut it into 5 or 6 inches for the broken areas. It costs me less than 2 dollars. Let me know how it turn out on yours.

Read Full Q/A … : Sport & Outdoor – Others

How do I get an instructional manual for the awning on my RV?
ANSWER : Kindly download the manual from the following website

http://bryantrv.com/owners.html

thank you

Read Full Q/A … : Sport & Outdoor – Others

Im looking manual instructions for coleman Sahara tent
ANSWER : Go on youtube, you will find some excellent videos on how to….on a range of tents. I saw the coleman sahara tent on a video last year as I was considering buying one! Good luck!

Read Full Q/A … : Sport & Outdoor – Others

Where can I find an instruction manual at for the Northwest Front Porch Tent?
ANSWER : This video is as good as anything although I wouldn’t pitch it on a hill! These are written instructions;

Start by stretching out the bottom of the tent into a square, and stake all of the perimeter tentloops to the ground, starting with the corners, with the stakes directed at a 30 to 45 degree angle under the tent, so the tent cannot easily pull them back out. Leave the yellow cords attached to the tentloops loose, so you can use the cords to help pull up the stakes when you take down the tent.

Now assemble the poles going through the loops across the front of the screen porch. Insert one end of a pole #1 into a pole #2 and thread them through the loops over the entrance to the screen porch. Put the long end of a curved pole #3 through the loops starting from one side, and attach to either side of the 1/#2 you made. Put the long end of another #3 through the loops starting from the other side and attach to the loose end of the #1/#2. You should tie the loose green cords on each corner of the sceen porch to the silver metal rings at the curved end of each #3.
Later, you will do the exact same assembly with a #3 on each side of a #1/#2 for the poles going across the back of the tent and the poles going through the pocket across the middle/top of the tent.

Now insert the small end of pole #4 into the curved end of a #3, then insert the small end of a #5 into the open end of the #4. There should be a rubber foot on the bottom of the #5 pole. Do the same thing for the other side of the porch. With help, you should be able to prop up the front of the sceen porch, pulling aganst the stakes holding the rear floor of the tent, and place the rubber feet of the #5 poles close to the center loops of the floor on each side.

Now prepare the #1/#2 poles for the rear, and attach a #3 to each side and tie the loose green cords to the silver rings on the short ends of the #3s. Prepare a #4/#5 pole the same as the front, and prop up the back of the tent, putting the feet near the side loops of the floor which are about 1/3 from the rear of the tent.

Make another #1/#2/#3, and push it through the pocket across the middle of the tent, and connect the last #3 from the other side. The side supports for the middle are pole #8 with the white clamp on the bottom, and pole #7 slid into pole #8 (The #7 was scraped off both of mine). Leave the #7 mostly inserted into the #8 until after the center is lifted up. The #6 goes on top of #7, and insert the #6 into the curved end of the #3 poles which are already in the center pocket, and tie the loose green cords to the silver rings at the short end on each of the #3s. Now lift up the center with someone helping on the other side, and put the feet of the #8 into or near the yellow loops at the center of each side. Loosen the white clamps and extend the #7 poles until the peak of the tent is at proper height.
Move the feet of the #5 poles closer to the tent, until all is tight, and you should be done!

Setting up Northwest Territory Front Porch Tent

Read Full Q/A … : Sport & Outdoor – Others

Swiss Gear Tent – Broken Poles SG33071F
ANSWER : Take a look on amazon for replacement. here: Amazon com tent poles. I hope this was helpful. Cheers

Read Full Q/A … : Sport & Outdoor – Others

How can I find manual instructions for pitching an Ottowa 600 Outwell tent
ANSWER : You can find here on youtube link https://www.youtube.com/user/Outwelltents/videos

Or go to youtube and research for Outwelltents

Read Full Q/A … : Sport & Outdoor – Others