What is the difference between a Mossberg 500 and a Mossberg 535 max 4.

ANSWER : This will sound sort of stoopid but trust me, more folks do it than you would believe. First thing….push the shell all the way up into the mag tube til your thumb is up the first knuckle. If you only push the shell til you hear the first click, you’re only pushing it past the first stop. With it one stop in, a pump will drop it on the floor every time. Simple way to prove that, load three shells into the tube but only load the last one til you hear the one click. Pump it. First hits the floor, rest load perfectly. See what I mean? On ALL pump shotguns, you have to hit both stops so push the shells in up to your first thumb knuckle.

ANSWER : I’d be amazed if Mossberg didn’t have one available. Give them a call.

ANSWER : I had the same problem and all i did was remove the primary and secondary clutchs clean them with mag wheel cleaner and installed a new belt works good now.

ANSWER : Put jumper cables from battery to starter directlyto see if it turns over faster put red on starter lead and black on gorund(metal housing)You may want to try this from a car battery to see if it spins faster if it does it indicates a problem with power from new battery check cables and lines for power blead

ANSWER : That forearm is designed for the 7 5/8″ slide action tube. I’m guessing yours is the 6 1/2″ slide action tube. Take the forearm off your tube and measure it with a ruler. From the very back edge of the action bar collar….that round part the bars are pinned to….all the way to the front edge of the threads. If yours is a 6 1/2″, the Hogue adapter won’t work. You’ll need to buy a new slide action tube. That Hogue adapter is meant to let you use the Hogue rubber coated forearm on your standard sized tube….the Hogue rubber forearm is a hair longer than the standard tube. It won’t give you the length to make up the entire shorter tube length. If you’re handy with a dremel, you could go adapter plus a bit of careful cutting but I won’t suggest you do it if you aren’t certain of your skills.

ANSWER : Four w d actuator is faulty replace actuator

ANSWER : Rule 7.2. Scoring
a. Points are earned during the play of the cards for the following single-card or combination of consecutive cards played. The player playing the last card that forms a combination earns the points (see scoring chart in Rule 1.7):

pair
three of a kind
four of a kind
straights of three or more cards in any sequence
a cumulative count of 15
the last card before player calls “go” (i.e., cannot play a card that would not make the count exceed 31)
a cumulative count of 31
the final card played, not making a cumulative count of 31

Here is the scoring chart:
http://www.cribbage.org/rules/rule1.asp#section7

Rule 1.7. Scoring Chart

Points Earned

Cards
During Play
Hand or Crib

Jack turned by dealer as starter card
2
–

Jack in hand or crib of same suit as starter card
–
1

Combinations:

• Two of a kind (pair)
2
2

• Three of a kind (triple)
6
6

• Four of a kind (quadruple)
12
12

• Straights of three or more cards: per card
1
1

• 15-count (sum of any combination of cards)
–
2

• Four-card flush (only in the hand)
–
4

• Five-card flush
–
5

Reaching a 15-count exactly
2
–

*Reaching 31-count exactly
2
–

*”Go” (without reaching 31-count)
1
–

*Final card played (without reaching 31-count)
1
–
* Only one of these scores can be earned with the play of a single card.

Note the * in the chart and this comment:

* Only one of these scores can be earned with the play of a single card.

i.e you either count the run or the 31

Thanks for using FixYa

Kelly