My son has a 52″

ANSWER : It would take a frankenstein of conectors to go from a gas bottle to a soccer ball. i would get a ball needle and have it soldered to a gas hose fitting. any welding supply store would have the gases and fittings you would need and would probably be willing to help if you tell them what its for

ANSWER : Here is a website with manuals…http://www.jiffyonice.com/Operating-Manuals.html

ANSWER : Just sit it on the ground where the deer trail is and your good to go.

ANSWER : I’m not sure where you live but (http://www.vikingoptics.com/compassrepair.html) are good.

Nik

ANSWER : Are you pumping the gun??? Once you have bb’s in the gun you have to **** it and then pump the foregrip 10 times then pull the trigger…….

ANSWER : The Gun should be looked at by a gunsmith for your safety and the safety of your son and anyone else that comes into contact with it.

From Wikipedia info:The Model 12 (introduced in 1912) was the next step from the Winchester Model 1897 hammer-fired shotgun, which in turn had evolved from the earlier Winchester Model 1893 shotgun. The Model 12 was designed by Winchester employee Thomas Crossly Johnson, and was based in large part on a design by John Browning. It was an entirely new hammerless design and was initially available in 20 gauge only (12 and 16 gauge guns were not sold until 1914). The Model 12 was the first truly successful modern hammerless pump-action shotgun ever produced. Its tubular magazine was loaded, and the action was fed, through the bottom of the gun. Empty shotgun shells ejected to the right. Depending on the particular wooden transformer plug installed in the magazine, 2, 3, or 4 shells could be stored in the tubular magazine. Without a plug, the magazine will hold 6, 2 3/4″ 12 ga. shells. With its forged and polished steel parts, the ultimate reason for the end of its regular production in 1963 was that it had become too expensive to produce at a competitive price. The primary competition at this time came from the much less expensive Remington Model 870, which had been introduced in 1950. In addition to price competition issues, the Winchester Model 12 rarely had parts break or wear out, often serving multiple subsequent owners, which further served to limit repeat sales. The majority of “modern” Model 12 shotguns manufactured after the 1930’s were chambered for 2¾-inch shotgun shells, only. Some early Model 12’s, however, were chambered for 2 9/16-inch shotgun shells. To add further confusion, some of these early Model 12’s have subsequently been modified, with their chambers lengthened to accept 2¾-inch shotgun shells, while others remain in their factory-stock 2 9/16-inch chamber lengths. Careful inspection by a gunsmith is always recommended to determine whether or not it is safe to fire a modern 2¾-inch shotgun shell in older Model 12’s.Special commemorative examples were nonetheless produced by Winchester after 1963 through 2006, through specialized gun collector purchase programs, but the Perfect Repeater shotgun was never mass-produced after 1963. The Winchester factory announced a complete closing of the factory facility in January 2006, thus ending the Model 12’s long and illustrious career at the age of 95 years.This site is for the R&R of the barrelhttp://www.nrapublications.org/TAR/Winchester12.asp

ANSWER : There are a few things that can cause the belt to stop running. First thing to do is check the lubrication and adjust the tension (get a manual from the manufactures website if you don’t have one, it will cover this adjustment). Next, clean the speed sensor wheel with compressed air or a q-tip and apply Paraffin wax under the belt and adjust tension if needed.