Sport & Outdoor – Others

Experienced athletes share their insights in answering this question:
An engine needs 3 things to operate.

Air
Fuel
Spark

Make sure you have all 3 of these.

How to Identify and Resolve Common Issues ?

We offer a diverse range of insights on identifying and resolving common problems in sports. Our sources encompass academic articles, blog posts, and personal essays shared by seasoned athletes. :

The battery can be fully charged but still not be able to start the vehicle if it is failing or has a dead cell. Other likely issues are the fuel pump, ignition switch, battery cables, starter, or a clogged fuel filter.
It might be a battery or alternator problem.

Perhaps your battery`s dead, or your alternator, which charges the battery, isn`t working correctly. If the source of the clicking is electrical, the starter (a small motor energized by the battery that gets the engine running) doesn`t have enough juice to stay powered.

Starter Motor. If the battery appears to be charged (the headlights, stereo and other accessories work) but you only hear one click, then the problem probably lies with the starter motor or the solenoid. The solenoid is the switch that engages the starter motor so it turns the flywheel and starts the engine.
Dead car battery: A dead battery is the most common reason why a car won`t start. If you have a battery tester, check your battery to see if it`s weak. If you don`t have one, try to jump start your car with jumper cables.
If your vehicle won`t start, it`s usually caused by a dying or dead battery, loose or corroded connection cables, a bad alternator or an issue with the starter. It can be hard to determine if you`re dealing with a battery or an alternator problem.
Batteries with open cells may read fully charged in idle, but they fail under a load test every time. Once a battery reaches this point, there is no going back. The best thing to do is recycle the thing.
Why won`t my car start but the battery is good? If your car won`t start but the battery is good, the most common cause is a faulty starter – though it could also be to do with your fuel. You may have insufficient fuel to get the car going.
When you attempt to start the vehicle, is there a clicking sound, but it won`t turn over? That may be a good sign. If a jump gets the car running, but won`t turn over again once it`s shut off, a dead battery is likely the cause.
You hear a single click

Usually, this points to a faulty relay or solenoid, or a bad or jammed starter motor. Solution: Rock your car back and forth or tap the starter motor with a hammer and try starting the engine again. If this works, you are good to go!

Partially or fully-discharged batteries may not provide accurate test results, so you`ll need to at least attempt to fully-charge it before having a load test done.
A fully charged 12 volt battery should read at 12.6 volts on the multimeter. If the reading is lower than this, you`ll want to charge your battery with either a battery charger or by taking your car for a drive.
Minimize the batteries at 100% state of charge

Keeping the state of battery charge, from 0 percent to 100 percent , also improves the performance of the battery life of your vehicle. Even though a full charge will give you the maximum operating time, it is never a good idea for the overall lifespan of your battery.

If there is no sound when you turn the key, but the lights and accessories work, it could be the stater relay or starter solenoid. However if there is no sound at all, not even a click, it`s probably your battery.
It requires a good deal of energy to crank the car`s motor, and if a battery is not replenishing its power properly due to a faulty alternator, it will become drained and ineffective. You will hear a clicking noise while attempting to start the car, and the engine will have difficulty turning over.
If the battery is completely dead, it won`t have enough power to turn over the engine, even with a jump start. In this case, you`ll need to replace the battery to get your car running again.
Even if your lights, radio or accessories turn on, your battery may still be dead or undercharged. These components require a lot less power than the starter. Therefore, your battery may have enough ability to turn the radio/lights on, but not enough to turn on the starter.
An effective method to determine whether it`s your battery or alternator that`s gone bad is to connect jumper cables from a running vehicle`s battery to yours. After a few moments, try starting your vehicle. Once it`s started, remove the jumper cables — if your engine stalls, your alternator has probably gone bad.
If the battery is good and the engine turns over but your car still won`t start, the fuel system may be to blame. Over time, water can build up in the fuel tank due to condensation. If this happens, the water can get into the fuel line and freeze, blocking fuel from getting to the engine.
An effective method to determine whether it`s your battery or alternator that`s gone bad is to connect jumper cables from a running vehicle`s battery to yours. After a few moments, try starting your vehicle. Once it`s started, remove the jumper cables — if your engine stalls, your alternator has probably gone bad.
If the battery is good and the engine turns over but your car still won`t start, the fuel system may be to blame. Over time, water can build up in the fuel tank due to condensation. If this happens, the water can get into the fuel line and freeze, blocking fuel from getting to the engine.

Discover Relevant Questions and Answers for Your Specific Issue

the most relevant questions and answers related to your specific issue

I have the Intex Sand/Pump pool filter Model SF 20110. It’s been running real great for the last 4 months. However recently it has been tripping the internal overloads and I have found the pump motor to be very hot when I put my hand against it. I have tried several different solutions, such as a level ground platform that was clear of any obstructions, made sure that the motor vents under the motor was clear of anything that would prevent air flow. I used a non electrical type of lubricate on the impeller. When I would turn on the pump the rotor would not turn but only would hum very loudly and then slowly begin to turn. I also noticed that the motor’s rotor shaft would not turn to freely due the tightness around the rotor’s shaft. After using the lubricate the shaft would turn a little easier. I used an amp meter on the incoming voltage line and the motor would run at 4.5 amp. And yet it still overheated and tripped the motor overloads. I can only think that the motor is still not getting enough ventilation. I have check and cleared all the incoming lines and found nothing block the pumps input or output lines. Any suggestion?
ANSWER : I just looking into this issue my self. The pump cools itself by a internal fan, which is run by the motor. Well I took the housing cover off to find out all the fan blades have broken off and were setting in the base of the pump. Once you remove the fan blades from covering the air intake, it might be fine. I will find out my self once summer gets here.

Read Full Q/A … : Sport & Outdoor – Others

Motor will not start, battery is fully charged, turn the key and get clicking sound. lights will not turn on
ANSWER : An engine needs 3 things to operate.

Air
Fuel
Spark

Make sure you have all 3 of these.

Read Full Q/A … : Sport & Outdoor – Others

Motor was running great, but it died slowly and never start again
ANSWER : Check to see if you have a spark -then check if you are still getting fuel-and how old is the fuel-because it is recommended ,an im assuming its a 2 stroke motor,that the fuel should be replace with a fresh 2 stroke mixture every couple of months as the mixture jellyfies and sludges up the carb etc-try those first

Read Full Q/A … : Sport & Outdoor – Others

3 year old Toro Z4200 time cutter Z, 19 HP Kohler, engine runs great, new battery, new solenoid, with the seat sensor connected or by-passed, STILL WONT start off the key switch. Clicks at the kill relay. Would the kill relay be the problem?
Whats confusing is, both the green and blue posts on the solenoid have 14.01 volts when you turn the key to ‘start’ position. Did the same thing with the old solenoid, which is probably still good. I replaced it to eliminate that variable. It also ‘clicks’ at the fuel switch at the carburetor bowl, but that is only 1 lead (I assume a hot lead) so Im thinking that CANT be it.
Using the old hillybilly method, jumping across the 2 top posts on the solenoid, with the key in on position, it will start right up, run, drive and mow just fine.
So my best guess is this ‘KILL RELAY’ must be bad?
Any help would be appreciated, thank you !
ANSWER : These things are pre requisites for engine cranking: PTO/Blades are off/button pushed down, the steering arms are out/parked position, and you are in the seat. I think. Definitely the blades have to off.

Read Full Q/A … : Sport & Outdoor – Others

I have a 1991 Yamaha 250 outboard motor. I can connect the harness from the control box to the motor harness, put the motor in nuetral, and the motor will turn over but it will not start. I can disconnect the conrol box from the motor, jump it direct from the battery, and it will start. What might be the problem? I even bought a new control box but still have the same problem.

Thank you,
Dean Youngstrand

ANSWER : I would check for power coming off of the ignition switch. The ignition switch is what sends power to the control box to the coil. You can also check for power on your coil. But I would bet that it is your ignition switch.

Read Full Q/A … : Sport & Outdoor – Others

I have a 1997 motor guide wireless 24volt Big Water trolling motor. hooked it up to the batteries and put in a new 9volt battery in the foot pedal. the lights come on on top of the motor head and the foot pedal beeps, but the prop doesnt turn or spin (like there is no power to the bottom of the motor) any suggestions to what the problem is or how to fix it? (just bought the motor from a lady who’s husband died. dont have any manuals)
ANSWER : Hello there, as you said the power does not get to the bottom of the motor. The motor could be faulty or just completely bad. First you have to determine that the motor is good until you can determine this it is quite impossible to determine if there can be any fix. Take out the motor and try to power it on its own if it works fine then the problem is not from the motor but most likely the problem is from the motor. Let me know what your findings are. Hoping to hear from you soon.
Thank you for visiting FixYa.

Read Full Q/A … : Sport & Outdoor – Others

Pop-up camper lights all turn on when tow-vehicle lights are on
ANSWER : FIRST, make sure white wire of camper is grounded to the frame of tow-vehicle. Temporarily use a jumper-cable frame-to-frame. Then apply 12volts individually to each of the three circuits to the camper. Assuming a 4-wire flat connector — brown wire is for marker lamps; yellow is left brake/turn; green is right brake/turn

Read Full Q/A … : Sport & Outdoor – Others