Sport & Outdoor – Others

Experienced athletes share their insights in answering this question:
They are both at a great advantage, I am sorry to say, but I
cannot determine which I think is better strategically. Here is why:

A player who shoots first may have their weight
knocked off by their opponent; however on the second turn you should then aim
your weight to the opposite corner of the table. •
A player who shoots last has the ability to know
off their opponents weights or have a final chance to get their last weight
into a superior scoring position.

## How to Identify and Resolve Common Issues ?

We offer a diverse range of insights on identifying and resolving common problems in sports. Our sources encompass academic articles, blog posts, and personal essays shared by seasoned athletes. :

The rules of shuffleboard state that the player listed second on the playing card shoots with yellow discs, while the player listed first shoots with black discs, after which players switch on the next round. You shoot a yellow disc first to start the game.
Using the rail to guide your shooting hand, the side-wheeling shot is the standard and more accurate method of shooting. This method, which is particularly helpful on longer shuffleboards, involves directing the puck with your thumb, index, and middle fingers while your ring and pinky fingers use the edge as a guide.
Games are played in frames until one player or team scores 51 points. Every player or team gets to finish each frame and the highest score is the winner (51 points or greater). If the player or team that scores 51 points or more has the hammer (the last player or team to play), then they are declared the winner.
A line is drawn across the court, six and a half feet from the end. This is the “baseline” and the area from the end to the baseline is called the “shooting area”. From this line to the next line, one and a half feet beyond, is the “10 Off” area.
Scoring is based on the numbers of the compartments 1 – 4. For each set of four disks constructed by taking one from each compartment, 20 points are awarded (i.e. 1 + 2 + 3 + 4 doubled). After the sets of four disks have been removed and tallied, any remaining disks score the amount shown on their compartment.
The hammer is the shuffleboard version of “game point.” A coin toss before play determines which player shoots first and who gets the hammer. The winner of the toss usually chooses the hammer, as having the last shot gives an advantage.
o NO BUST – The first team to 21 or more points wins. There is NO penalty for exceeding 75 points. o NO SKUNK – There is NO mercy rule. All games will be played to 75 points.
They may not require a lot of running about (if they do, you`re playing them wrong), but there`s no denying that the fastest reflexes get you the most reward. The reason why shuffleboard is so popular is that anyone can play – it is a game of patience, tactics and sleight of hand.
Common Shuffleboard Game Rules

Try to make it to the highest scoring area on the shuffleboard without falling off the end of the board into the alley. In order to earn points your weights need to be the farthest down the board.

Scoring: Only one team scores in a round. The team which has their weight closest to the end of the board scores. All of their weights which are ahead of their opponent`s deepest weight (closest to the end of the board) are added together for the score for that round.
The 10 scoring zone is at the peak of the overall scoring triangle, and is 3 feet in height, from the Top-8 line to the peak of the triangle. A further dead-line or lag-Line runs from side to side 12 feet from the base-line (The dead-line is therefore 3 feet from the tip of the triangle).
You shoot all pucks towards the opposite end as in other games. The scoring zones are the same (1, 2, 3 and 4 for a hanger). However, the multiplier is used to multiply the total amount of points. For example: If you slide 1 red into zone ONE, and 2 reds into zone TWO, your current score would be 5.
Shuffleboard games can be played to 50, 75, or 100 points. Typically, the first person, or team of doubles, to reach 75 points wins the game. The game is played in half rounds and scores are tallied at the end of each half round. Scores cannot be counted until all 8 discs have been played.
Pucks hanging off the edge of the farthest zone are called “hangers” and are worth an extra point. Keep playing rounds until one side reaches 15 points. This completes a frame. Complete matches usually consist of three frames.
Though there are many differences between table shuffleboard and deck shuffleboard, both kinds are a great source of fun for all ages.
The birth of table shuffleboard. Shuffleboard has endured as a popular game for centuries, first showing up during the 1500s across the pond in the taverns and parlors of Great Britain. The original name of the earliest form of shuffleboard was simply “shove a penny,” as that action was the basic gist of the sport.
If a puck travels to the end of the playing surface and hangs over the edge, the scoring value is four points. Once all the shuffleboard pucks have been played the points are tabulated based on which player`s pucks are closest to the far end without going beyond the scoring area.
So… if you go negative, just give everyone else 1 VP per negative score (instead of going negative). This would be the same as starting everyone with more VPs.
Sprinkling shuffleboard sand — also known as shuffleboard wax or shuffleboard powder — on your board is essential to ensure the pucks glide down the table correctly. This silicone-based powder also helps preserve your board.
Curling is a winter target sport in which the objective is to slide stones on a sheet of ice towards a target area. The game is an ice version of shuffleboard. Curling is one of the sports of the Winter Olympics. Curling is a team sport, played between teams of two or four players.
The team that gets to throw the last stone in a given end is said to have the “hammer.” When a team scores points in an end, their opponent gets the “hammer” in the next end.
Shuffleboard “Sand”

Shuffleboard wax, otherwise called sand or salt, is a what is sprinkled on table to diminish rubbing between the puck and the table. It likewise assists with saving the tables thickness, and speed up loads as they coast across the table.

While ages ago shuffleboard powder was made from sawdust, today it is made from dried silicone beads and corn meal. It usually comes in a round container not unlike a powdered cleaner. The holes at the top are arranged in such a way that the powder can be spread evenly around the table.
Silicone Spray

With the entire table coated, let it sit for a few minutes, then gently buff off the remainder with a towel. The silicone spray will work to increase the effectiveness and speed of your shuffleboard table.

## Discover Relevant Questions and Answers for Your Specific Issue

the most relevant questions and answers related to your specific issue

My swimming pool. I have just had my fifth IC 40 Intellichlor chlorine generator installed in 4 years at a cost of over \$900 today. Each one has worked for no more than 8 months. The first three were replaces under three year warranty, the fourth by a factory rep and I bought the fifth today. The first three all failed with Flow Chk PCB error message. The fourth just stopped working on Sunday, no power or lights. A local Pentair warranty person, whom I paid a Service Call, unplugged the unit, opened the small power center cover, showed me the green light indicating that there was power, plugged in a new IC 40 which worked immediately (as did the other four). I asked if I should replace the power center and he said that it’s basically just a transformer and is working fine. We do get occasional power blips that make the clocks on microwaves, etc blink, but I thought that the power center essentially isolates the cell from these. I do have a Florida Power and Light surge protector on the electrical box that brings power into the house. I have now talked to the pool builder, two Pentair warranty repairmen and one factory rep. I am at a loss. They all tell me they have no idea why these units fail after less than a year. This last IC 40 was installed 3/24/2010, version 2.0 and now failed in less than 5 months. Should I replace the power center that the IC 40 plugs into. Any other suggestions. I have been told that this is the best chlorinator. I don’t want to keep replacing units. By the way, each unit had been spotless inside. I keep the water chemicals and salt levels at ideal levels. The units have never worked long enough to get dirty inside. The power center is connected to an Intellitouch control system outside with an indoor control panel. Last time I called Pentair North Carolina and got some smart alec tech person that had no suggestions. Please Help if you can.
ANSWER : I’ve had the same experiance. On my fifth one as well. Fail every year. No idea why.

Read Full Q/A … : Sport & Outdoor – Others

Kettler tennis table has rusty legs, one is very bad
ANSWER : To stop this much rust – go to any hardware store and buy (I forget the exact name) a “paint” called Rust Stop. It will stop the rusting and turn the existing rust into a hard black surface that you can then paint.

Read Full Q/A … : Sport & Outdoor – Others

ANSWER : Get to the manufacturer

Read Full Q/A … : Sport & Outdoor – Others

I have a Scuba Pro X650a regulator. After having the unit serviced this winter I used it last month for the first time in St. Croix.

The first day of diving went fine. However, as the week progressed I noticed that when taking in a breath the regulator continued to trickle air at a very small rate. While not enough to be concerned about safety at this point it has become an annoyance both from the fact that bubbles continue to trickle past my ears and air usage has increased. This is an intermittent problem.

I had it looked at by 2 certified Scuba Pro Dive shops and they could not find anything wrong with it though one did lower the first stage pressure just to a bit to see if that would work. I also cycled the control lever position for “dive” and “surface” intervals to ensure that there were no sticking problems.

It does appear that the problem is intermittent and that it only occurs when the regulator is under water.

In addition is there a diagram in which I can use to troubleshoot this problem?

NOTE: this version of the X650 was not on the recall list of Scuba Pro.

Any help would be appreciated.

Stephen

ANSWER : Strangely enough I had the exact same problem with mine.. I’m in the caribbean I love diving and spear gun fishing.. I had one of these a year ago with the same issue I actually wound up increasing the pressure to get it to work.. It wasnt muc use cause my air ran out at a faster rate. Was never able to fix ,, A buddy of mine had the same issue ,, wound up replacing the swivle vale and this helped for a week and then back to the same old .. I then changed to the Aqualung Mikron Regulator had no issues and it works great .. Quite frankly I think we had bad ones here but I’m not sure where you got yours. If you wish you can replace the swivle valve (most likely cause) but I’ll just change the unit and get another..

Read Full Q/A … : Sport & Outdoor – Others

I have purchased three 750-watt power inverters in the last three weeks. They have all failed to work on the second or third use. The first two were the same brand. I replaced an old one that ran for several years. I am using it to run a 4.7 amp 120-volt vacuum cleaner motor that pumps up my air dock. I have it connected directly with marine cable to one of the boat batteries. The battery outputs about 12.8 volts DC. The fuses don?t blow, just No Output. I am using a three-wire 120-volt extension cord and am, wired neutral, hot and ground to the AC motor vial an on/off switch. The motor works fine when I run house power with an extension cord from the dock next to me. Could I be, just unlucky with new inverters and need to buy a forth one?
ANSWER : The problem may be that the inverter is undersized for the load. Is the 4.7 Amp rating the motor peak draw or the nominal one. What I mean is that it takes many times more power to start start the motor than when the motor is running. Typically it is 3 to 7 times more amps to start the motor than when it is running. It could be that starting the vacumm cleaner is stressing the inverter and it is causing it to fail prematurely. If you can find out the locked rotor current draw of the motor, the that would be the mininum size of the inverter.

Also, the type of inverter will make a difference on how the motor operates. A modified sine wave will make the motor run hotter than a pure sine wave inverter. Hope this helps.

Read Full Q/A … : Sport & Outdoor – Others

I bought a new mossberg 590 a1 shot gun a month ago, I love the gun but its having a couple of problems, the first problem is that when shooting every once in a while i get sprayed in the face with exuast from shooting through the safety very scary! any ideas whats causing this? how to fix it? second is that some times the fireing pin sticks and the gun will not discharge a round? the third problem is that i have had feeding issues with gun where it will not realice a gound from the tube, ive taken a tip of a knife to the stuck round in the tube and it prys out with little effort, these problems dont happen every time i go shooting, just every once in a while, but they a happening more and more, im conserned cause the gun is brand new, and i wanna be safe while shooting, can you guys help me? any ideas/solutions? please help!!!!!!!
ANSWER : Personally, with that many problems, I’d call Mossberg and get a return authorization. None of these things should be happening, especially with a new gun.

Read Full Q/A … : Sport & Outdoor – Others

Help! Just bought a Remington 30 06 for my grandson that has a Bushnell Sportview U4124 4-12power scope mounted on it. I would like to sight it in at 100 yards using a 180 grain shell but I don’t have the owners manual and I don’t understand an on line explanation that I found. This is the on line message: “You’ll see two horizontal crosshairs, put the top one on the animals back then zoom in until the bottom one is on his stomach. Look at the numbers on the zoom dial there should be three lines they are D – deer, E – elk and A – antelope. The numbers are the distance to the game, you then turn the external elevation knob or turret to the matching distance and shoot dead on. No need to hold over for bullet drop. The sad part will be if you didn’t get the other turrets that would have come with it as they are calibrated to different calibers and bullet weights”
I don’t understand how to set the elevation knob to 100yards when its lowest shown number is 150. If I need other turrets how or where can I get them? Thanks, a frustrated grandfather.
ANSWER : You can contact the Remington directly who will ship you a free users manual. Here is the company’s Contact Us details:

http://www.remington.com/pages/our-company/our-company/company-info.aspx

You may also find the required answer in the official help center. It covers almost every fields. Here is the link:

http://remington.custhelp.com/

Read Full Q/A … : Sport & Outdoor – Others