e a schematic available for this system so I can fix it and where can I get it from?
Coleman

Experienced athletes share their insights in answering this question:
Hello,

You will have to contact them to get the information you requested. Their contact info is listed below.

Coleman Trailers – manufactured by Fleetwood Enterprises, Inc.
– Before 2006 –
Toll free: 1-800-544-8193

Customer Service Email:[email protected]
Website: www.coleman-rv.com

Regards,
Tony

How to Identify and Resolve Common Issues ?

We offer a diverse range of insights on identifying and resolving common problems in sports. Our sources encompass academic articles, blog posts, and personal essays shared by seasoned athletes. :

The whiffle tree is the threaded rod mounted in the bottom of the pop up. A draw bar runs up and down the rod, and pulls or releases the lift cables. Plastic delrin nut / acme screw whiffle tree.
The VIN number can be found on your registration, and on the VIN plate. The VIN plate is typically found on the campers tongue. Use the Vin Decoder to identify your year.
The main function of your lifting system is to lift your camper off the trailer to prepare to “unfold” your camper top. This works with a series of pulleys and winches. The winch will perfectly connect with the main cable that runs under the roof of your pop-up camper.
Pros & Cons of Pop-Up Campers. Perhaps the most accessible category of RV or trailer products, pop-up campers are incredibly versatile. From camping trips to overlanding and much more, they`re a great way to experience the outdoors without sleeping on the cold, hard ground.
The invoice and dealer receipt. The invoice usually includes the make and model number of your RV. Your owner`s manual and operating instructions. Your RV model number should be printed on any of the new owner materials provided by the manufacturer.
Phillips 66® Cable Lube is a heavy-duty lubricant developed for the lubrication and preservation of wire ropes and cables. It is formulated with a heavy residual base oil along with special rust and corrosion inhibitors and is cut back with a volatile, non-chlorinated solvent for ease of application without heating.
When it comes to setting up and breaking down, pop-up trailers are easy to use, especially if you`re new to the RV camping experience. Because of their smaller size, they`re easy to set up on leveling blocks when you pull into your campsite.
Since a pop up is a soft-sided RV, the canvas will get wet and will need to dry out. You can put a tarp or awning over the top to help keep the rain from hitting the camper directly. Be careful of high winds that can send branches down from surrounding trees as they can create tears in the canvas sides.
In general, if an RV comes from the manufacturer with a built-in ladder on the back, that ladder is intended for roof access. This indicates that it`s safe to walk on the roof.
Pop-up camping tents are made from lightweight, waterproof materials such as nylon or polyester and feature flexible frames that provide structure and support. Pop-up camping tents usually come in a dome shape but are available in other options.
An ultralite or ultra-light travel trailer is any travel trailer designed to be both lightweight to tow and more aerodynamic than a typical travel trailer. Ultralite RVs typically use lighter, still-durable materials for construction, inside and out.
With a pop-up camper, you can choose to go with a really basic unit or take it up a few levels and look for something much fancier. The most basic model will include a bed, dinette or small bed, an icebox, and generally a propane stovetop with two burners.
With a pop-up camper, you can choose to go with a really basic unit or take it up a few levels and look for something much fancier. The most basic model will include a bed, dinette or small bed, an icebox, and generally a propane stovetop with two burners.
Inside the pop up camper it does get moist. Its just a step above a tent, but does seal out all the water from the rain. We have a mini dehumidifier in which we will run. Our air conditioner also acts as a dehumidifier which helps with humid weather.

Discover Relevant Questions and Answers for Your Specific Issue

the most relevant questions and answers related to your specific issue

Jayco lift system cable replacement
ANSWER : Try this link and see if it will help you any with the info that you need. Sure hope this helps you find resolution to the problem. Best wishes.
http://www.ehow.com/how_4708883_repair-jayco-camper-cables.html

Read Full Q/A … : Coleman

HI!
I continually get code 90 (low/NO flow) from my 8111. I have disassembled, cleaned EVERYTHING, including the inlet port AT the pump (remind everybody to check this as stuff gets past the filter basket and will plug the pump inlet).

There is No air in the system and I get superb pressure at the outlet, yet I still get code 90. I again removed the flow sensor and put my ohm meter across the flow sensor terminals and activated the flapper and measured an open circuit. I used a heavier magnet to see if I could get make the internals of the sensor move to get an ohm reading, but I get nothing but an open circuit, ie: no measured resistance.

Can I simply bypass the defective flow sensor to trick the 8111 to think it has full flow without damaging the ‘brain’ of the system.?

Intex corp is useless at these questions. They have been out of stock on this sensor for months and are telling me “two weeks” for two months and now it’s “end of August” which I do not believe. Meanwhile I am making no chlorine while the 90 code is showing.

I love the 8111, this is the first problem I’ve had with it, and I’m frustrated that I can not get such an important part from them.

Thanks for listening!

ANSWER : Have you been able to find a solution to this problem. I am having the same issue.

Read Full Q/A … : Coleman

I can’t get the cable to stop popping off of the pulley underneath the bench press seat. Every time I try to lift weight using the bench press, quadricep curls, or anything that puts pressure on the cable connected to these exercises, the cable pops off the pulley. If you could show me how to get a diagram of how to run the cable or give me another solution to this problem, I would be deeply obliged.

Thanks,
Kendrik

ANSWER : Hello,I had same problem. I fixed it by taking plastic sides off using a long
phillips head screwdriver. Jay, you don’t have to take the sides off to
fix your problem. The sides come off only to untangle and rewind cables
on pulleys. Pull the cables all the way out. Have a helper pull out and
keep holding out the tension knob This is shown at the bottom of page
nine in the manual. With someone holding the tension knob out turn the
large pully located beneith the tension knob CLOCKWISE! I screwed mine
up by turning it counter-clockwise. This winds the handle to the top
and if you start with all the cable pulled off the pully, the cable
should then wind itself nicely back onto the pully. Once the handle is
all the way up, with the round ball on the cable jammed up against the
pully, then and only then let go of the tension knob and let it fall
back into place. If the handle falls down a few inches repeat this
proceedure but push lower pully a bit harder and try to turn tension
knob, while it is pulled out, in the opposite direction and it will
then click into place one notch tighter and should hold the black ball
on the cable firmly against the pulley. Let me know if this was helpful.wish you good luck,take care.

Read Full Q/A … : Coleman

Broken Cable on Pop-up trailer need help
ANSWER : Try this link and see if it will help you any with the info that you need. Sure hope this helps you find resolution to the problem. Best wishes.http://www.ehow.com/how_4708883_repair-jayco-camper-cables.html

Read Full Q/A … : Coleman

How to tighten cable on pop up camper
ANSWER : The adjustment can be done by your dealer, contact them see how much it costs.

Read Full Q/A … : Coleman

Broken cables to lift roof
ANSWER : Http://www.customcylindersintinc.com/camper_trailer_roof_lift_system.htmThis should help, Pictorial and instructions. Also parts available.Thanks for using FixyaJerry

Read Full Q/A … : Coleman

Cracks in the top
ANSWER : Nice solution should work, and yes bad design by coleman. you can also paint roof with camper roof paint silver with fiber

Read Full Q/A … : Coleman