How to set up tent – Sport & Outdoor – Others

ANSWER : The 2 longest of the poles go in an x over the center of the tent and the 2 shorter ones go arch to the sides. http://www.wenzelco.com/details.aspx?NavID=412shows a picture very similar to your tent. If you go to image 2 it shows it with out the fly. now if you got 2 sets of 4 poles, 2 long and 2 short, and one set is all aluminum, then I would go with the aluminum set. It is less likely to collapse in high winds.

ANSWER : Hi. How may buttons do you have, 3 or 4 buttons?if you have the 4 buttons, try this:You need to go through the time and date settings again. The 24 and 12hr format select is at the end of time/date adjustment.To set the time and date:-press the top-left button then right-top button to set the seconds, press bottom-left button to set hour then press top-right button to adjust hour, press bottom-left button to set the minute then press top-right button to adjust minute. To set date, press the bottom-left button then press top-right button to adjust month, press bottom-left button then top-right button to adjust day and finally press bottom-left button to set the time format then press top-right button to select 12hour format. Press top-left button when done.Since you have a generic sports watch, it is hard to write specific instructions to set the time format. If your watch has different ways of setting the time, just remember that the 12/24hour format is usually at the end of time and date adjustment.Let me know if you have questions. Good luck.

ANSWER : If you go to any good tool store or engineering store you can get what is known as helecoil insert.just tell them the inside diam of the pole.they will probably put it in for you if yuo take the pole along.hope this will help.regards barry.

ANSWER : If you get four sturdy poles (not normal tent poles) then the best thing to do is to stake the four poles into the ground at a 60 degree angle with the top away from the tent and then use the tension created by the angle to support the tarp.

ANSWER : I have a 2002 Infinity 6 man spa that I just got from a friend. I am also an Electrician. I had to replace the Spa pack because it wasn’t working. Once I replaced the Spa Pack and used the tub it got up to temp no problem but once I got in the temperature slowly dropped and it couldn’t keep up. After some research and discussion with a pool tech I found out that there is a jumper on some spa packs. It is a LC (low current) / HC (high current) jumper. It limits the current (amperage) that your tub draws. If you are running it on the LC setting it keeps the tub at low current by not running the heater when the jets are on. (this way it keeps the current low by running one only at a time) If you set it for HC it will allow high current to be drawn and let the heater and the jets be on at the same time. On my spa pack it is P26 Jumper. I have found it is also listed as Jumper 4 on some spa packs. the jumpers are located in the lower right of the circuit board. Make sure you shut off the power to the tub and know what you’re doing before you attempt changes. you can also google “Gecko Spa Pack Service Manual” and you will find the manual for your tubs spa pack. Good luck.

ANSWER : Take a look on amazon for replacement. here: Amazon com tent poles. I hope this was helpful. Cheers

ANSWER : Go to Home depot and buy a tube that fit the pole. Cut it into 5 or 6 inches for the broken areas. It costs me less than 2 dollars. Let me know how it turn out on yours.