How to load the line on the spinner Shakespeare Proam 350RF

Think it may be a line tension problem. every

I have a Daisy 2003 35 shot repeater pellet gun. I do not know how to load the red magazine.
There is a black slide pin on the mag, and a place to, i think, load each pellet individually.
Does the slide pin have to be in a certain position to load the pellets?
Do I load each pellet individually?
Thanks for your help
Russ

Cannot open Shakespeare Synergy Steele 2001s fishing reel

Unable to read camera on laptop to load pics

I have the Intex Sand/Pump pool filter Model SF 20110. It’s been running real great for the last 4 months. However recently it has been tripping the internal overloads and I have found the pump motor to be very hot when I put my hand against it. I have tried several different solutions, such as a level ground platform that was clear of any obstructions, made sure that the motor vents under the motor was clear of anything that would prevent air flow. I used a non electrical type of lubricate on the impeller. When I would turn on the pump the rotor would not turn but only would hum very loudly and then slowly begin to turn. I also noticed that the motor’s rotor shaft would not turn to freely due the tightness around the rotor’s shaft. After using the lubricate the shaft would turn a little easier. I used an amp meter on the incoming voltage line and the motor would run at 4.5 amp. And yet it still overheated and tripped the motor overloads. I can only think that the motor is still not getting enough ventilation. I have check and cleared all the incoming lines and found nothing block the pumps input or output lines. Any suggestion?

LX 188. Engine suddenly dies. The fluel in the bowel of the fuel filter is empty. If I crank the engine the filter becomes dry and is collapsing some but the engine does not start. When I remove the supply line from the fuel pump to the carberator and crank the enginge there is a strong stream of gas being pumped out. I tap on the carberator ??? is the float is hung not allowing fuel to enter. Cranking the engine with the line off refills the bowel of the gas filter. Reattache line to the carberator===engine starts. Ran perfect for 20minutes then suddenly died. Repeated all the above and engine again started. What to do to fix this? Thanks

Help! Just bought a Remington 30 06 for my grandson that has a Bushnell Sportview U4124 4-12power scope mounted on it. I would like to sight it in at 100 yards using a 180 grain shell but I don’t have the owners manual and I don’t understand an on line explanation that I found. This is the on line message: “You’ll see two horizontal crosshairs, put the top one on the animals back then zoom in until the bottom one is on his stomach. Look at the numbers on the zoom dial there should be three lines they are D – deer, E – elk and A – antelope. The numbers are the distance to the game, you then turn the external elevation knob or turret to the matching distance and shoot dead on. No need to hold over for bullet drop. The sad part will be if you didn’t get the other turrets that would have come with it as they are calibrated to different calibers and bullet weights”
I don’t understand how to set the elevation knob to 100yards when its lowest shown number is 150. If I need other turrets how or where can I get them? Thanks, a frustrated grandfather.