Sport & Outdoor – Others

Experienced athletes share their insights in answering this question:
Depending on your
power outage and charger however it should take between 4 – 6 hours to recharge
your gun.

How to Identify and Resolve Common Issues ?

We offer a diverse range of insights on identifying and resolving common problems in sports. Our sources encompass academic articles, blog posts, and personal essays shared by seasoned athletes. :

On average, firing one BB out of AEG costs about one mAH of electricity. This makes the math for calculating how many shots you can expect to get out of a single charge quite simple. If you are using a 1,400 mAH battery, for example, you can expect to fire about 1,400 rounds before your battery goes dead.
About 10-24 hours, depending on how weak your battery is. If you`re using a trickle charger, expect it to take days. Don`t expect an under-charged battery to do the job of a fully charged one.
It`s 2A charge rate can fully charge an AEG 2.0Ah battery in approximately an hour so you can get back to work faster.
It takes about 2 hours to full charge 8.4V / 9.6V 1600mAh NiMH battery packs.
Charge times are (3.5-4.5hrs) do not leave on charge overnight. Battery should be unplugged from the charger after a maximum 8 hours.
It is recommended that you take at least two batteries to an Airsoft Skirmish in case one should go flat. The length of time a battery lasts varies entirely from gun to gun, and the way you use the weapon. The more shots you take, the more power you will use.
a car battery, drive around for about 30 minutes to enable the alternator to recharge the battery to a decent capacity. While the jumpstart can give it a little juice, your battery needs more time to get any significant charge to start on its own.
Rechargeable batteries typically last between two and five years and can be recharged hundreds of times. While they cost more than alkaline batteries, they last longer per use than alkaline batteries and end up saving you money in the long run.
NiMH batteries – like any rechargeable battery – will self-discharge if left unused. Generally, within 30 to 60 days, batteries will become almost completely drained. When using them, you will need to first recharge them.
For example, a high capacity power bank with 20,000 mAh can take up to 40 hours to charge fully. Smaller power banks with 4,000 mAh may only take a couple hours to charge.
Nickel-Cadium Batteries (NiCad)

Overcharging it can cause battery cells to split, leak, and even cause a fire so they should never be left alone even with a smart charger.

For a 3000mAh battery pack, set the charge current to 1.8A. The charging time will be 1.5 hours.
10,000mAh /1,000mAh=10 hours. If you use a 5V/2A power adapter, it takes 5 hours to fully charge the power bank: 10,000mAh / 2A (2,000mAh) = 5 hours.
Airsoft games typically last between 15 to 30 minutes. Each airsoft game has a unique set of objectives and unique respawn rules which change the length of gameplay.
It is estimated that one cartridge lasts about 80 shots, so it goes quite fast. The advantage of CO2 – powered airsoft guns is that they are very powerful, so if you want high muzzle velocity, you should look for your equipment among gas models.
Charging a regular car battery with a typical charge amp of around 4-8 amperes will take about 10-24 hours to charge it fully. To boost your battery enough to be able to start the engine, it would take around 2-4 hours. The best way to maintain a long life for your car battery is by recharging it slowly.
It takes most vehicles about 30 minutes of driving at highway speeds to fully recharge the battery. Keep in mind that 30 minutes is an average. If your battery is severely discharged, it may take even longer to recharge it.
A car battery can be charged in the following time: 40 Amps: 30 minutes to an hour. 20 Amps: 2 to 4 hours. 10 Amps: 3 to 6 hours.
You can jump-start the dead vehicle and drive it to let the alternator replenish the battery charge. Alternatively, you can attach the dead battery to a battery charger. If the car battery voltage is under 12.2V, you may want to use a trickle charger to avoid battery overcharging or overheating.
You can`t touch the wires in your 120V AC household electrical system without getting a nasty, dangerous shock, but you can touch bare wires carrying 12V DC in your car, even lay your hands across the positive and negative 12V battery terminals, without risk of electrocution.
For example – a battery which is kept fully charged at all times will last much longer than one which has been undercharged or kept at a reduced voltage.
Avoid storing, using or charging batteries at very high or low temperatures. Protect batteries against being damaged – that`s crushed, punctured or immersed in water. Don`t leave items continuously on charge after the charge cycle is complete – it`s best not to leave your phone plugged in overnight for example.
Leaving the battery on charge You can leave a battery/radio in the charger once charging is complete. Leaving a battery in the charger will not overcharge or damage it. You can remove a battery/radio from the charger at any time without harming the battery, the radio, or the charger.
Don`t overdo it.

Disconnect chargers and devices with rechargeable batteries after the battery reaches full charge. Overcharging occurs when the device or battery is plugged into a charger after full charge has been reached and may reduce battery life.

Discover Relevant Questions and Answers for Your Specific Issue

the most relevant questions and answers related to your specific issue

How long does it take to recharge my battery for my automatic Electric Gun?
ANSWER : Depending on your
power outage and charger however it should take between 4 – 6 hours to recharge
your gun.

Read Full Q/A … : Sport & Outdoor – Others

Club Car 1998 Electric DS Golf Cart. Battery charger was unplugged for a month or so and once realized it was plugged back in but batteries have not recharged. How can we get the batteries to recharge?
ANSWER : Take the batteries into any major name auto parts store (NAPA, Parts Plus, Auto Zone, etc) and have them do a load test on them. If you have a 12 volt system the battery must hold 11.5 volts under a load to be able to take a charge. If under that voltage it will need a replacement

Read Full Q/A … : Sport & Outdoor – Others

Do I have to take the gun apart to get the battery in the gun???
and also before i was done with the gun my brother put the paintballs in the hopper but for some reason they were falling out of the barrel. Did I do something wrong???
ANSWER : No, you didn’t do anything wrong… Paintballs come in a variety of sizes. That difference is very hard to see with the naked eye, but your barrel knows what fits and what doesn’t. Players have a choice in barrels and ID-internal dimensions, so the balls are various sizes as well. You will have to sample a few brands and see what works best for you.Good luck!

Play hard, play safe, play with honor!

8^)

Read Full Q/A … : Sport & Outdoor – Others

I have a Vector VEC1378 rechargeable lantern – does this lantern also take a battery or must it be electrically charged only? If so, how do you open the battery case.

Thank you.

ANSWER : I have the same and bought a $20 6v lead acid replacement from the Batteries Store. There are 4 small screws hidden under the foam rubber ring pad on the bottom. Very easy to open and swap out the battery. That said if you want to sell me your old lantern as is, I would enjoy having a second one for camping. Thanks and good luck. I can be reached at rudock1 at yahoo dot com. -Billy

Read Full Q/A … : Sport & Outdoor – Others

I bought a new mossberg 590 a1 shot gun a month ago, I love the gun but its having a couple of problems, the first problem is that when shooting every once in a while i get sprayed in the face with exuast from shooting through the safety very scary! any ideas whats causing this? how to fix it? second is that some times the fireing pin sticks and the gun will not discharge a round? the third problem is that i have had feeding issues with gun where it will not realice a gound from the tube, ive taken a tip of a knife to the stuck round in the tube and it prys out with little effort, these problems dont happen every time i go shooting, just every once in a while, but they a happening more and more, im conserned cause the gun is brand new, and i wanna be safe while shooting, can you guys help me? any ideas/solutions? please help!!!!!!!
ANSWER : Personally, with that many problems, I’d call Mossberg and get a return authorization. None of these things should be happening, especially with a new gun.

Read Full Q/A … : Sport & Outdoor – Others

I have a tippmann custom pro with a cyclone feeder. I recently got the SAW stock to put on it and encountered some problems many times after I reassembled the gun. I took it apart at least 5 times before I thought it was fixed but now ive encountered another problem. I believe it has to do with the cyclone feeder not responding or something is out of line in the gun. When I picked up the gun to shoot, no paint came out so I took off the CO2 and the barrel and saw that the paintball was 1/3 inside the gun. I also have a problem when im shooting it sometimes does really fast burst. Thank you
ANSWER : Hi there. Tippmann markers are super tough to make sure that they are put back together properly. The stupid clamshell design plus all the little, under engineered parts make it difficult to get it back together properly, especially after installing a stock. I was in the paintball industry for 10 years but have been out of it for a little bit, but i was one of the founding members of Uprising Nation and was a gunsmith/ salesman for PaintballOnline.com / Xtremes. Now with that said…I even had trouble with the tippmann 98’s…and I can rebuild an autococker with my eyes closed but can sometimes be stumped by the tippy’s bad design. It is really tough to diagnose an issue on these guns without looking at it. You may have the ball detent backwards,l missing a pin, sometimes the after market stocks on those are a little too large on the outside diameter preventing the internals from properly seating. The cycloce system may be off due to the valves not meing properly aligned or the connecting rod not being in all the way. Many times though it is incorrect installation of the detent or the deternt gets damages. That little orange peice of **** flap is a mance. I would start there.

It may seem like i am bashing your gun. Im not… Once they are put together properly they work great. Just DONT TAKE THEM APART. lol. If you buy the parts at a local gun shop they will install them for free.

lol I have 6 guns for sale 🙂

Have a good day

Read Full Q/A … : Sport & Outdoor – Others

The control screen operates by a battery which is charged by cycling. We were in a car accident and it was unused long enough to run down the battery. When this happened before, we cycled till it was charged and then it worked. Now though, it is stuck at a level that we can hardly peddle at–not long enough to charge the battery. Any solution?
ANSWER : Hello.

You may need to pull the battery out and take it to a re-conditioner. In Australia a company called battery world can test the battery, re-condition or replace if needed.
if there is a way of using a external charger on it this may give you enough power to adjust the pedal resistance, be sure to disconnect the battery from the bike before charging and use the correct type of charger for that batteries voltage and chemistry
You can try manually releasing the pedal pressure by removing the wheel and releasing the resistance wheel or belt. With out a model type I do not know exactly how to do this, although it is fairly easy to see when the main wheel is off the bike.

I hope this points you in the right direction.

Regards
GM

Read Full Q/A … : Sport & Outdoor – Others