How do you use the slingshot? wristband seems to be in wrong place.

I have an iron gym however I cannot place it above the door frame because there is nothing there to hold it in place. Will I need to use a drill to place the iron gym..I hope not because I do not know how to use it.

Hiya I have a fujifilm e-900 I have used the camera less than 20 times. The last time I used it I had no problems at all. I had left it sitting in it’s case for 6 months. Now when I try and us it I get the hand with lightning bolt on the lcd. Which I assume means the battery encasement is open. It isn’t open. The camera turns on no problem then when I try and use any function it shuts down. How do I fix this?

I bought the Knoxx adjustable stock for my mossberg 500. The forend that comes with it is realy nice and Ide like to use it, but the end nut will not reach the threads. Do i need to buy a new adapter nut that is longer to secure my forend ? I saw one for sale by houge but wasnt sure if that would work on the knoxx forend ?? I realy like the forend sent by knoxx, would be a shame not to use it. What a waste to give that nice piece away and not give the adapter to use it ?? Thanks Noel

I have a TX500, never been used (just out of the box) and had to get an electrician to my home for this problem. It will start rolling but quits in a few seconds. The electrician believes that it is a problem in the sensor that rides at the belt. There is only one sensor in the pulley; he thinks that perhaps there should be two as there is a hole placement opposite the one that is in there. When the belt quits, it goes to a number 3 on the board which he thinks is the sensor as well. If he is correct, where do we get another magnet to place there? If he is not correct, please offer help. We did not get a owners manual in the box and surely could use one; where can we get one? Please help…thankyou

Dc side of my electrical seems to short out

I have purchased three 750-watt power inverters in the last three weeks. They have all failed to work on the second or third use. The first two were the same brand. I replaced an old one that ran for several years. I am using it to run a 4.7 amp 120-volt vacuum cleaner motor that pumps up my air dock. I have it connected directly with marine cable to one of the boat batteries. The battery outputs about 12.8 volts DC. The fuses don?t blow, just No Output. I am using a three-wire 120-volt extension cord and am, wired neutral, hot and ground to the AC motor vial an on/off switch. The motor works fine when I run house power with an extension cord from the dock next to me. Could I be, just unlucky with new inverters and need to buy a forth one?

I have the Intex Sand/Pump pool filter Model SF 20110. It’s been running real great for the last 4 months. However recently it has been tripping the internal overloads and I have found the pump motor to be very hot when I put my hand against it. I have tried several different solutions, such as a level ground platform that was clear of any obstructions, made sure that the motor vents under the motor was clear of anything that would prevent air flow. I used a non electrical type of lubricate on the impeller. When I would turn on the pump the rotor would not turn but only would hum very loudly and then slowly begin to turn. I also noticed that the motor’s rotor shaft would not turn to freely due the tightness around the rotor’s shaft. After using the lubricate the shaft would turn a little easier. I used an amp meter on the incoming voltage line and the motor would run at 4.5 amp. And yet it still overheated and tripped the motor overloads. I can only think that the motor is still not getting enough ventilation. I have check and cleared all the incoming lines and found nothing block the pumps input or output lines. Any suggestion?