Sport & Outdoor – Others
How to Identify and Resolve Common Issues ?
We offer a diverse range of insights on identifying and resolving common problems in sports. Our sources encompass academic articles, blog posts, and personal essays shared by seasoned athletes. :
By comparison, this 3-dial lock (three wheels, each with digits 0-9) has 10 × 10 × 10 = 1, 000 possible combinations.
The 4 digit lock has 10,000 combinations.
A three digit code with 10 digits has 10^3 or 1,000 combinations, from 000 to 999. To list them, just count from 000 to 999, left-padding numbers less than 100 with leading zeros (000, 001, 002,…, 010, 011, …, 097, 098, 099, 100, …).
The factory-set combination is 0-0-0-0. Push the reset lever left and down. The lever will remain in this position while you reset the combination. Rotate the dials to your desired combination.
A three digit code with 10 digits has 10^3 or 1,000 combinations, from 000 to 999. To list them, just count from 000 to 999, left-padding numbers less than 100 with leading zeros (000, 001, 002,…, 010, 011, …, 097, 098, 099, 100, …).
Discover Relevant Questions and Answers for Your Specific Issue
the most relevant questions and answers related to your specific issue
”The protector” gun safe I need a user manual
ANSWER : If it is “The Protector” from Costco, open the door and put your hand back by the top of the rear of the door in the seam. There you should feel a little button, push and hold til it beeps then enter your 4 digit code, hit “A” and release. Lock the wheel with door open and make sure your new code works.Good luck!
How to reset counter?
ANSWER : I suggest check this procedure, work for all models: stepinstruct.pdfHope this help.
I have a 2006 small Stanley air compressor (HP 2.0 peak).When I turn it on it clicks the reset botton.Sometimes it will slowly turn over then click it.Maybe after 10-20 times of attempting to start it and resetting the reset it will start.Please help.Thanks -Joe
ANSWER : Hi,The start capacitor is bad… that is what gives the motor enough “kick” to get the motor started…Replace the capacitor and it will work just fine again..heatman101
Bell f20 resetting trip odomoter DST
ANSWER : Did an obsessive search of this problem and found this: “Right Button” . . . click to display the “DST” (distance) than hold the “LEFT Button” for 2 seconds. YEAH!! Reset trip ONLY!! This problem is simply an error in the instruction manual. ~G~
We have a pop-up with the sink that folds down. We need to replace the sink drain from the sink to outside, but the only flex drain hoses that I can find have a hose only 26 inches long. I know that will not be long enough to go from the sink to the outside of the camper.
Do you know if any place I can go to get a sink drain system with a longer hose. The contraption (I don’t know what it is called) at the base of the sink drain has rusted off so that the swivel part of the drain system is gone. We currently have a garden hose connected to the pipe coming directly from the drain, but when we close the camper, it pops off.
Do you have any suggestions?
Thanks
Michele
ANSWER : Hi mj2181,I would say your problem should be solved easily with a hose extension , if you can get the extension and then use it , it should be ok for you and there should be no need to get a sink drain system with a longer hose.An example of an extension hose can be found on this link :- http://www.searspartsdirect.com/partsdirect/part-number/7174401GS/0071/580?sid=SPDx20101101xNXTGHope this helps ,
Im trying to open the front top to my 4001s synergy steel push button fishing reel but dont know how
ANSWER : Was a great reel until the pin stopped coming out to reel in the line. Most reels have a removable nut to service the pin springs. this reel doesn’t allow access – crazy!
XD Picture Card
ANSWER : It does say 128 in the manual, but I would assume that is because that was the largest available at the time of print.
As long as the card is XD, the storage capacity should not matter.