Coleman

The tent has many poles; how are they arranged?

How to Identify and Resolve Common Issues ?

We offer a diverse range of insights on identifying and resolving common problems in sports. Our sources encompass academic articles, blog posts, and personal essays shared by seasoned athletes. :

so how long does it take to set up this coleman. 10 percent instant tent with two people to take everything out and unpack the tent flat on the ground will take about two minutes from there propping the poles up and extending all of them will take another one and a half minutes draping a rain fly over the tent.
Keep away from setting up where there is washout (leaves and the dirt pattern is a good solid indicator). The tent should be placed in a position that allows water to drain away from the tent, so that you don`t have a river running through it. Set up your tent away from where you are going to be eating.
Even though dome tents look difficult to set up alone, they are actually one of the easiest tents to assemble by yourself! If you have a newer dome tent, it is simpler than ever to put one together. However, a lost instruction manual can mean the difference between an easy task and a much more difficult one.
Peg the back down first – by pegging down the back of the tent first, even before any poles are in, you can anchor the tent, preventing it blowing away in the wind. You can then go and re-peg once you`re done. Don`t force the poles too much or they could break.
Sandbags. Sand is accessible, cheap, and, thankfully, heavy enough that, when evenly distributed across your tent`s frame, can efficiently anchor your setup. Sandbags, like the ones we sell, can weigh about 35lbs each when filled with sand and a little bit of water.
One person can easily put up an instant tent depending on its size and design. If the tent is a 6- to 10-person tent, it can be harder to set up and install the rainfly. However, if the design of the tent is simple enough, one person can probably still manage it.
Coleman tents can last at least 5 years if they are well taken care of, and are used lightly. This includes but is not limited to using a footprint while camping, cleaning and drying the Coleman tent after use, and storing it properly when not in use.
Coleman Tent Construction

Fiberglass is best used for casual summer camping trips and smaller, personal tents. However, aluminum tent poles are almost always an upgrade in terms of strength, weight, and durability.

Ventilation must ensure a steady supply of fresh air/oxygen (for reasons of both safety and sleep), as well as control condensation out of the tent. The ventilation system must be able to do this in two ways: through ventilation and ventilation.
Placing a tarp under your tent extends the lifetime of your tent by protecting it from wear and tear caused by rugged terrain. Sharp rocks, sticks, or tree roots can tear or puncture the bottom of your tent. A tarp also insulates your tent, minimizes moisture, and makes it easier to clean your tent.
Pop-up tents are the fastest tents to set up. They`re already assembled, with all the extra-bendy poles already inside the tent sleeves, and packed into a round package. You simply need to take the pop-up tent out of the bag, and, as the name implies, it pops open.
The tent-pole technique is an effective method for increasing the horizontal ridge dimension, minimizing postoperative complications, and facilitating subsequent implant placement.
Pegging it in Place

Tent pegs should go into the ground at an angle away from the tent with the bent part facing outwards. This will not only give you extra resistance, if the bent part is in the ground there will be less chance of the peg twisting out in the wind.

If you look at the numbers, the only safe method to properly anchor your tent is to add more stakes in the ground. The following anchoring devices should also be explored: load distribution bars, anchor bars, screws, anchors and others. Anchoring with Weights.
At least 200 pounds is needed to properly anchor a tent of that size to concrete and other hard surfaces. A 10×15 canopy tent requires about the same weight, but has a lower wind rating when only using footplates. A 10×20 requires more weight to achieve a 35 mph wind rating.
PUT A HEAVY-DUTY TARP UNDERNEATH YOUR TENT.

If a piece of tarp sticks out from underneath the tent, the rain will strike the tarp and roll underneath the tent, where the tent floor is likely to soak it right up. Fold any excess tarp under the tent so that you cannot see any of the tarp.

: to prepare an area for sleeping outside. The hikers set up camp just before sunset.
Well, the outer wall of a tent protects it from the air, water, and other elements by using extra-durable material. On the other hand, the inner layer is more breathable, allows better ventilation inside the tent, and prevents the build-up of condensation.
Modern tents made of polyester or nylon are most often treated and have a high HH, so you usually do not need to worry about touching the inside – they still wont leak. Cotton and canvas tents (older) are usually untreated and have a lower HH, so they will leak via capillary action when touched from the inside.
Most tents are designed to withstand a certain amount of wind, however speeds over 30 mph can cause damage. Remember to take rain ponchos and lots of plastic bags. Pack your clothing and bedding in plastic bags before packing into rucksacks.
If you have bought a cheap tent, you expect some leaking in heavy rainfall. But when you`ve bought a high-quality tent and spent good money on it, you`re not going to be happy.
There`s a reason Coleman tents are one of the most well-known and widely respected brands out there. Their combination of quality and affordability just can`t be beaten and makes them the perfect choice for first-time campers and veteran outdoorsmen alike.
Quick answer: Three-season tents are usually only about 5 degrees F warmer inside than outside. Winter tents are better designed to trap heat and are typically 10-15 degrees warmer inside. Insulated or expedition tents can be over 25F warmer inside.
The tent`s outer fabric is fire retardant and for extra security, the zipper stoppers on the tent doors ensure that zips are always within easy reach in the event of an emergency, even for children.

Discover Relevant Questions and Answers for Your Specific Issue

the most relevant questions and answers related to your specific issue

Square tent with 2 types gazebo poles, varenda, 2 side windows
ANSWER : The 2 longest of the poles go in an x over the center of the tent and the 2 shorter ones go arch to the sides. http://www.wenzelco.com/details.aspx?NavID=412shows a picture very similar to your tent. If you go to image 2 it shows it with out the fly. now if you got 2 sets of 4 poles, 2 long and 2 short, and one set is all aluminum, then I would go with the aluminum set. It is less likely to collapse in high winds.

Read Full Q/A … : Coleman

I need new poles for Swiss Gear tent # SG33071F
ANSWER : Go to Home depot and buy a tube that fit the pole. Cut it into 5 or 6 inches for the broken areas. It costs me less than 2 dollars. Let me know how it turn out on yours.

Read Full Q/A … : Coleman

How to stabalize four tent poles in an open area.
ANSWER : If you get four sturdy poles (not normal tent poles) then the best thing to do is to stake the four poles into the ground at a 60 degree angle with the top away from the tent and then use the tension created by the angle to support the tarp.

Read Full Q/A … : Coleman

Swiss Gear Tent – Broken Poles SG33071F
ANSWER : Take a look on amazon for replacement. here: Amazon com tent poles. I hope this was helpful. Cheers

Read Full Q/A … : Coleman

Instruction for setup of American Camper tent 8×11
ANSWER : Finally figured it out through trial and error. This right here is the only correct explanation given anywhere on the net.

First, make sure you have all of your poles. There will be 4 straight green ones, 4 straight blue, 4 straight burgundy with plastic feet, 4 curved yellow, 2 small orange arches, a straight pink and a straight white.

Before you start putting the poles together, stake the tent down at every loop point around the base of the tent. There should be 10 of them. Make sure they’re fairly tight and the floor of the tent is taught and flat but not so tight that you tear the tent at the seam. Stake 1 corner first. Then put the second stake through the second loop in order and using a firm pressure, pull away from the first stake, along the line of the tent base, make taught and push the second stake into the ground. Repeat until finished.

The first pole assembly uses in this order, going out from the yellow arch, which is in the center. From one side of that arch, add one green, then a curved yellow, then another green and a burgundy at the bottom. Do the same from the other side of the center arch piece.

This arch outlines the door and goes through the 3 loops on the front of the tent, around the door, so the poles hold the tent up. the loops at the bottom are not for the poles. Every loop around the bottom are where the stakes go to hold it down. For now point the feet towards the back of the tent wherever they will stand on their own. You can fine tune it and firm it up once you get the second arch in place.

All green ones should now be used up.

For the second arch, do the same thing but use the blue instead of the green. So from the one side of the yellow arch, 1 blue, 1 curved yellow, one blue and one burgundy. Same order from the other side of the arch.

Now all the poles should be used up except for the straight pink one and the straight white one. These two go together to make a straight pole that goes through the metal loops attached to the yellow arch pieces and locks the two arch assemblies apart at the top.

Now this takes some maneuvering and some word smithery to describe but what you want to do is make sure the feet of the front arch assembly, are pointed towards the back of the tent and stop at the side. The back arch feet will point towards the front of the tent. They both stop about 6 inches BEFORE the center tie down loop on the SIDES of the tent, on either side of the center loop. The front arch will actually lean forward, with the feet pointed behind it and wedged into the ground, right up against the tent at the bottom, move it around until you have a nice firm feel to it. Same with the back arch but this one will lean away from the back of the tent and the feet pointed towards the front. Once you get the back arch into place, it will really firm up and won’t budge.

Another way to describe it would be that the two arch assemblies feet will point towards each other at the side of the tent, about 6 inches before they reach the center loop on either side.

Hope this helped. =)
Posted on Jul 04, 2015

Read Full Q/A … : Coleman

Im looking manual instructions for coleman Sahara tent
ANSWER : Go on youtube, you will find some excellent videos on how to….on a range of tents. I saw the coleman sahara tent on a video last year as I was considering buying one! Good luck!

Read Full Q/A … : Coleman

How to put up a coleman tucana tent – Coleman 10' X 10' Sundome Tent 9160K101
ANSWER : Wow. They put more and more stuff on tents. I’ll give it a try based on a photo I found.First, peg the four corners down. This will help it from moving around.Find the two longest poles. These are your main supports and once you get them in, you can use the tent without the fancy rain cover (if you want to). They should run diagonally from the corner’s you pegged. Start at one corner and slide the poles through the sleeves in the top of the tent towards the opposite corner. The next two longest go from back to front. They do not cross diagonally. Slide these into their sleeves.Now the hardest part. Slide a pole into a peg hole or a pin (if your poles have holes in the bottom), then bend the pole and attach it to it’s corresponding corner. Just let the bent poles lay on the ground. Do the same with the others. It shouldn’t matter which poles go up first, but I would do the diagonals myself, then the side supports. Once these 4 poles are up, you’re in business.To attach the monster rain cover flip the whole thing over the top and figure out which side goes to the door. It looks like the lantern is on the right front. It looks like you should have two poles left. One may be the same size as the side support poles, or very close to it. This is the front door pole. The smallest pole is the side roof support.Slide the front door sleeve through it’s sleeve, then attach it to the pins or holes where the diagonally support poles are. They should have two pins in this spot, one for ea pole. Next, slide the side support pole side to side under the roof, but over the tent. It should have little pockets to put the pole into. Last, you’ll have to bungie the hooks to the little rings at each corner of the rain cover. Forget all the strings, unless you want to stake them out to stretch your tent a little. Hope this helped. Alley

Read Full Q/A … : Coleman