Sport & Outdoor – Others
How to Identify and Resolve Common Issues ?
We offer a diverse range of insights on identifying and resolving common problems in sports. Our sources encompass academic articles, blog posts, and personal essays shared by seasoned athletes. :
I finally found the manual here: http://www.sportline.com/products/sport-timers/228-giant-display-sport-timer.html & http://www.sportline.com/products/sport-timers/228-giant-display-sport-timer.html. To turn alarm ON/OFF: Press SPLIT/RESET/SELECT & START/STOP/SET at the same time.
Overview. This mode turns off the power to the operation panel and the fusing unit, and makes the machine wait in the lowest power consumption state. Auto Power Shut-Off Timer will activate when the set duration of time elapses in waiting status without executing a job.
Press and hold the SPLIT/RESET button to view the Alarm Time. 3. To turn the Alarm ON or OFF, press the START/STOP button while holding down the SPLIT/RESET button (the bell icon in the upper right-hand corner of the display is on when the Alarm is turned ON).
The expected life of the battery is approximately eight months, based on typical use. If the watch is used to time a short duration (or left running) on the repeat function with vibrating alert, then the battery life will be significantly shorter due to the higher battery requirements for vibration.
Therefore the least count of stopwatch is 1/3 second.
Discover Relevant Questions and Answers for Your Specific Issue
the most relevant questions and answers related to your specific issue
Pop-up camper lights all turn on when tow-vehicle lights are on
FIRST, make sure white wire of camper is grounded to the frame of tow-vehicle. Temporarily use a jumper-cable frame-to-frame. Then apply 12volts individually to each of the three circuits to the camper. Assuming a 4-wire flat connector — brown wire is for marker lamps; yellow is left brake/turn; green is right brake/turn
When i turn my camera on it says “lens Error” and i can’t take picture but i can view the pictures can you help! i am in europe and i can’t take pictures of anything please please please 🙂
That means that you forced some how the lens that goes out and in when zooming or turning of/on. so, check if the lens that goes out and in the camera is perfectly straigh compare to the rest of the camer. if it is the case try to force it with your hand to put it straight.
if that is not the case, it si more serious. the lens inside migh had moved or broken meaning you have to buy a new camera.
dont waste your time fixing it it will cost you the same as a new one.
When i go to stari my bike it doesnt turn over i
If it doesn’t turn over when you push start, but it does if you wiggle the key back and forth, it’s probably the ignition switch. Try to isolate the problem by only doing one thing at a time, such as wiggling the key while it’s in the on position, or pushing start several times. It might be the starter motor too, but that seems a less likely possibility if turning the key back and forth fixes it temporarily. The way to make sure would be to jump the ignition switch all together (hotwire it) to see if it always starts then. You should be able to find a wiring diagram to show you how to do this.
Kawasaki bayou 1992, i changed the starter it turns but does not engage, the chain turns the gear moves but moter turns doesnt turn over.. what am i overlooking, ive tried what i know and nothing works..
Sheared pin on gears(if the gear turns but not the shaft)
Cannot turn engine over to start. Ariens 924 snow blower
Pull spark plugs and see if it will pull over if not fuel may have filled the crank case drain & refill to proper level (starter is stuck in lube shaft & movethe gear up & down by hand to free up)
I have a Husqvarna LZ6127 zero turn mower, works hard on 50 acre farm, I was mowing last evening and it developed a nasty sounding rattle from the underside, I shut off the deck and noticed sparks from underside along pump belt, I lifted it today and the idler looks ok, I tried to start it while it was lifted and it turned a few times and then just clicked, starter won’t turn the engine over now, should I suspect the clutch?
This machine has a electro magnetic clutch,bolted to the end of the crankshaft, if the bearing in the centre has seized it would explain why the engine will not now crank, it relys on the crank turning on the bearing when the blade are not engaged, unfortunatley the clutch is non servicable, it is is part no. 539105406, check also the anti rotation bracket is still in place and fractured, this stops the clutch outer from spining with the centre, the clutch is just bolted on the end of the crank,remove the belt, you will have to loosen it by taking it off one of the blade pulleys, remove the 5/8 bolt, dissconnect the wiring connector, and pull the clutch off the end of the crank, if the bearing in the centre is solid, it will require a new clutch, be aware they can be expensive!.
I bought a Fujifilm Finepix A825 digital camera from my local Morrisons supermarket about 1 month ago as a Christmas present however, the camera seems to be malfunctioning. It turns on and will let me press buttons to scroll through the menu’s however 99 out of 100 times, if i press a confirmation button or try to take a picture it just turns itself off with the zoom lens still out. I am not sure what the problem is as it does let me take a picture every once in a while. Please help!
Take it back its under warranty