Sport & Outdoor – Others
I set my 1999 infinity atlantis SE outdoor hot tub to 104 degrees. I was in it for 1.5 hours and the temp dropped to 100 degrees despite still having it set. Aren’t they supposed to maintain the same temperature the entire time you use it?
Experienced athletes share their insights in answering this question:
I have a 2002 Infinity 6 man spa that I just got from a friend. I am also an Electrician. I had to replace the Spa pack because it wasn’t working. Once I replaced the Spa Pack and used the tub it got up to temp no problem but once I got in the temperature slowly dropped and it couldn’t keep up. After some research and discussion with a pool tech I found out that there is a jumper on some spa packs. It is a LC (low current) / HC (high current) jumper. It limits the current (amperage) that your tub draws. If you are running it on the LC setting it keeps the tub at low current by not running the heater when the jets are on. (this way it keeps the current low by running one only at a time) If you set it for HC it will allow high current to be drawn and let the heater and the jets be on at the same time. On my spa pack it is P26 Jumper. I have found it is also listed as Jumper 4 on some spa packs. the jumpers are located in the lower right of the circuit board. Make sure you shut off the power to the tub and know what you’re doing before you attempt changes. you can also google “Gecko Spa Pack Service Manual” and you will find the manual for your tubs spa pack. Good luck.
How to Identify and Resolve Common Issues ?
We offer a diverse range of insights on identifying and resolving common problems in sports. Our sources encompass academic articles, blog posts, and personal essays shared by seasoned athletes. :
If your filters are dirty and clogged up it can restrict the water flow, which is a common cause of heat loss. Clean filters are an essential part of good hot tub maintenance anyway so give them a thorough clean with a spa filter cleaner and see whether that makes a difference.
A hot tub temperature keeps rising, often because of the water level. If your water level is too low, the temperature can quickly become too high. Ensure that your water is at the recommended level and see if it can retain the set temperature after it cools down.
A hot tub can lose heat for a number of reasons. Perhaps you left the cover off, allowing heat to escape. Maybe there`s an issue with your heater. It could simply be a matter of build quality – if you`ve chosen a more cost-effective spa, it may lack the insulation required to properly maintain heat.
Water will cool faster when the spa is being used in cold weather whenever the cover is off, so the warmer setting can help offset that. If you have not winterized your spa and won`t be using your hot tub for extended periods during the coldest months, the very lowest you should set your hot tub temperature is 80° F.
We highly recommend using a thermal spa blanket to help keep heat in the tub. Finally, make sure your hot tub cover is in good shape so it will keep heat from escaping; a damaged hot tub cover can cause a lot of wasted energy because the heater will run constantly to maintain the set temperature.
yes! Hot tubs are designed to be left on permanently and this is how they work best. Of course, they`ll need to be drained regularly but for the most part, they are left on 24/7.
If you use your hot tub every few days or more, you should leave it at its regular temperature even when you`re not using it. Because spas are so well-insulated, once they get up to temperature it doesn`t take much energy to keep them there.
Faulty dip tube. Dip tubes push incoming cold water to the bottom of your hot water tank to be heated. If it has worn out or is otherwise defective, the cold water mixes with the heated water at the top of the tank. This decreases the overall temperature of the water that`s going to be sent to your shower.
Hot tubs don`t just have to be used in the winter; you can also use them to cool off in the summer too. Depending on how cool you want the water to be, we recommend experimenting with temperatures between 29 and 35°C to find the most comfortable temperature to suit you.
Should I Turn My Hot Tub Off When It Is Not In Use? No. Turning off your spa between uses does not save money. Once the water is heated to your preferred temperature, you`ll save energy—and money—by keeping it there.
One of the most common questions our team gets asked is “should I leave my hot tub on all the time?” Quite simply, the answer is yes… your hot tub is designed to be left switched on constantly and works best when it is left on all the time. Your hot tub is at it`s most efficient if left to run 24/7.
Can you turn off a hot tub when it is not in use? Yes, you can turn off your hot tub, but it`s better to keep it running. That said, there are a few occasions when it might be best to switch the tub off.
Staying in a hot tub for 2 hours is far too long. The general recommendation is around 15-30 minutes, depending on the temperature of the water.
Allowing your hot tub to sit empty during the hot summer months is no issue, as long as a cover is securely placed over the top. The cover is essential. Without it, your acrylic hot tub can easily become damaged when exposed to direct sunlight. This sort of damage is known to void a warranty.
How to Know if Your Ozonator`s Working: Look for bubbles: a working ozonator will produce a regular stream of bubbles from your hot tub`s drain. No bubbles or small bubbles could mean your ozonator needs to be cleaned.
How to Know if Your Ozonator`s Working: Look for bubbles: a working ozonator will produce a regular stream of bubbles from your hot tub`s drain. No bubbles or small bubbles could mean your ozonator needs to be cleaned.
To help your hot tub cool down, drain a little of the hot water, add clean, fresh water to reduce the water temperature. If you drain some water from your hot tub, be VERY careful to keep the water level above the filter housing. You don`t want to run the risk of running the pump dry!
Discover Relevant Questions and Answers for Your Specific Issue
the most relevant questions and answers related to your specific issue
I have a multifunction sports watch that i bought from Big W, (no brand name)
By accident i set the watch to 24 hour time, originally it was set to 12 hour time, how do i set it back? ive tried every button combo including the button combo i used when i accidently set it on 24 hour time, the instructions only say how to set the time and date, it doesnt say how to toggle between 12 hour and 24 hour time, is there a generic way to toggle it on sparts watches? btw, holding the mode button in does nothing on my watch, no matter how long i hold it in for
ANSWER : Hi. How may buttons do you have, 3 or 4 buttons?if you have the 4 buttons, try this:You need to go through the time and date settings again. The 24 and 12hr format select is at the end of time/date adjustment.To set the time and date:-press the top-left button then right-top button to set the seconds, press bottom-left button to set hour then press top-right button to adjust hour, press bottom-left button to set the minute then press top-right button to adjust minute. To set date, press the bottom-left button then press top-right button to adjust month, press bottom-left button then top-right button to adjust day and finally press bottom-left button to set the time format then press top-right button to select 12hour format. Press top-left button when done.Since you have a generic sports watch, it is hard to write specific instructions to set the time format. If your watch has different ways of setting the time, just remember that the 12/24hour format is usually at the end of time and date adjustment.Let me know if you have questions. Good luck.
Read Full Q/A … : Sport & Outdoor – Others
My bike won’t start after jump starting it, putting in gear it went dead & now the neutral light won’t shine.
& won’t start
& won’t start
ANSWER : Sounds like you fridge seilanoid try jump in across it with a screwdriver
Read Full Q/A … : Sport & Outdoor – Others
Coleman Hot Tub Model 411
ANSWER : This spa was manufactured by Maax. Try Maaxspas.com for your owners manual.
Read Full Q/A … : Sport & Outdoor – Others
This is the izh 513m .177 rifle. It’s brand new. I am not sure as of what to do and the hammer want budge and the trigger won’t pull. The barrel has no tension and it won’t go up like its supposed to.
ANSWER : This could be a factory safety that the hammer and trigger do not move while in the cocked position. The barrel may be locking down purposely. Look near the spring or in the path of the barrel where it folds back up and look for a release button. What do you see?
Read Full Q/A … : Sport & Outdoor – Others
Heater won’t blow hot in my coleman Seapine
ANSWER : My coleman quick-lite model 518b is not staying lite
Read Full Q/A … : Sport & Outdoor – Others
’06 Arctic Cat 250 DVX and the radiator fan won’t run
ANSWER : Are you getting power to the fan?if you are then this means the fan is bad.to test for power un plug the conector to the fan,start the machine and get it up to temp.take your wire tester 12 volt and see if it has power.if it does then the fan is faulty.if it dont then there is a bad wire you will need to chase it down with your tester.good luck.
Read Full Q/A … : Sport & Outdoor – Others
Caravan water heater not letting hot water through
ANSWER : Pipes are rusted and cloggen from the inside of them
Read Full Q/A … : Sport & Outdoor – Others
