to the touch. Is it a hernia and how serious can it be?
Sport & Outdoor – Others
How to Identify and Resolve Common Issues ?
We offer a diverse range of insights on identifying and resolving common problems in sports. Our sources encompass academic articles, blog posts, and personal essays shared by seasoned athletes. :
Inguinal hernia signs and symptoms include: A bulge in the area on either side of your pubic bone, which becomes more obvious when you`re upright, especially if you cough or strain. A burning or aching sensation at the bulge. Pain or discomfort in your groin, especially when bending over, coughing or lifting.
A hernia occurs when a weakness or a preexisting opening in your muscle or connective tissue allows an organ or other tissue to push through the barrier. Sometimes the weakness or opening is present at birth, but usually, it develops during your lifetime.
Vaginal hernia is a herniation of the peritoneum pushing downward through the pelvic floor into the vaginal vault or along the wall between the vagina and the rectum or bladder, sometimes extending between them all the way to the perineum.
Appearance. The hernia will look like a bulge or bump in the scrotum or groin region. Standing or bearing down with force will often make the bulge more noticeable. The bulge typically takes time to appear, but it can form suddenly after coughing, lifting heavy weights, straining, bending, or laughing.
An inguinal hernia is a soft lump in the groin or near the navel. It may be more visible when you cough. Hernias that disappear when you press on them may not need any treatment. Hernias that don`t disappear when you press on them may be more serious and need medical treatment.
In many cases, it causes no or very few symptoms, although you may notice a swelling or lump in your tummy (abdomen) or groin. The lump can often be pushed back in or disappears when you lie down.
Inguinal hernias are dangerous because they tend to keep getting larger and your intestine can get trapped inside the bulge and lose its blood supply. This is called a strangulated inguinal hernia, and surgery may be needed to correct the problem.
Hernias don`t go away on their own. Only surgery can repair a hernia. Many people are able to delay surgery for months or even years. And some people may never need surgery for a small hernia.
Hernias could cause abdominal pain
The area may be sensitive to the touch, even if you don`t have a noticeable hernia bulge. Pain can feel like a burning or aching sensation, which may get worse with strain.
If it is left untreated, a strangulated hernia can lead to life-threatening conditions such as necrotizing enterocolitis (severe inflammation of intestine) and sepsis. Since hernias can happen to anyone at any age, knowing warning signs of hernias and being aware of them are essential.
Symptoms. Abdominal wall hernias are generally visible: they will look like a lump or bulge beneath the skin. These hernias don`t usually cause any other symptoms except for mild pain or discomfort, usually when you are straining (for instance, lifting something heavy).
Depending on the type (and area) of hernia repaired, the swelling may vary and the time for the swelling or bulge to go way can range up to six months or above.
If it`s trapped tightly, the intestine`s blood flow can get cut off. Get help right away if you have a hernia and these symptoms: Bulge is dark, purple, or red.
Absolutely Yes! If your hernia is not causing pain or discomfort – it is possible to live with your hernia. One must remember that there is a risk of an emergency (incarceration or strangulation) from any hernia.
Indeed, many hernias go unnoticed and undiagnosed for years, decades or even the remainder of the patient`s life. Asymptomatic hernias, as they are known, do not warrant treatment, in most cases, because we simply do not know they exist, but also because the risk of strangulation is very low.
These medications — known as proton pump inhibitors — are stronger acid blockers than H-2-receptor blockers and allow time for damaged esophageal tissue to heal. Over-the-counter proton pump inhibitors include lansoprazole (Prevacid 24HR) and omeprazole (Prilosec, Zegerid).
Generally, hernias aren`t life threatening, but you can develop serious complications. If you notice any of the following symptoms, you should speak with your medical provider right away: sudden pain that gets worse quickly. nausea and vomiting.
It`s important to note that while hernias can be painful, they don`t all require immediate medical attention. It`s important to seek medical advice if: you experience severe or persistent pain. the bulge or lump associated with your hernia becomes red or discoloured.
Fatty Food – Saturated or trans fats food items such as red meat, processed food, high-fat dairy products, hydrogenated vegetable oil should be strictly avoided because these food items lead to inflammation and an increase in weight that possess the risk of increasing the problem of hernia.
Fibre-rich, low acidic foods like apples, pears, carrots, sweet potatoes and leafy greens are good dietary choices when you have a hernia.
An inguinal hernia associated with perforated sigmoid colon cancer is extremely rare, and the treatment of this condition is challenging. The incidence of malignant tumors within the inguinal hernia sac is reportedly 0.4–0.5% among the cases with excision [1, 2].
Normal activities can gradually be resumed over time when they can be carried out without feeling any pain. The latest hernia repair techniques usually allow you to return to normal activities within 2 weeks.
Many patients feel well enough to perform normal daily activities – including driving and return to work – after only a couple of days, but we restrict patient activity for 2 weeks to allow for adequate healing. Patients should not exercise or do any heavy lifting for the first 2 weeks after hernia surgery.
Some evidence is that exercise or yoga can help with or speed up the healing process after Hernia surgery. Exercise and yoga are recommended by physicians and physical therapists for a healthy lifestyle. Understanding the right exercises and the time to begin them from your doctor is important.
Discover Relevant Questions and Answers for Your Specific Issue
the most relevant questions and answers related to your specific issue
HI!
I continually get code 90 (low/NO flow) from my 8111. I have disassembled, cleaned EVERYTHING, including the inlet port AT the pump (remind everybody to check this as stuff gets past the filter basket and will plug the pump inlet).
I continually get code 90 (low/NO flow) from my 8111. I have disassembled, cleaned EVERYTHING, including the inlet port AT the pump (remind everybody to check this as stuff gets past the filter basket and will plug the pump inlet).
There is No air in the system and I get superb pressure at the outlet, yet I still get code 90. I again removed the flow sensor and put my ohm meter across the flow sensor terminals and activated the flapper and measured an open circuit. I used a heavier magnet to see if I could get make the internals of the sensor move to get an ohm reading, but I get nothing but an open circuit, ie: no measured resistance.
Can I simply bypass the defective flow sensor to trick the 8111 to think it has full flow without damaging the ‘brain’ of the system.?
Intex corp is useless at these questions. They have been out of stock on this sensor for months and are telling me “two weeks” for two months and now it’s “end of August” which I do not believe. Meanwhile I am making no chlorine while the 90 code is showing.
I love the 8111, this is the first problem I’ve had with it, and I’m frustrated that I can not get such an important part from them.
Thanks for listening!
ANSWER : Have you been able to find a solution to this problem. I am having the same issue.
Read Full Q/A … : Sport & Outdoor – Others
What does the lower ball joint look like – Moog 2006 Buick LaCrosse Lower Ball Joint 06 Buick Lower Ball Joint K5
ANSWER : This is the lower ball joint
Read Full Q/A … : Sport & Outdoor – Others
My swimming pool. I have just had my fifth IC 40 Intellichlor chlorine generator installed in 4 years at a cost of over $900 today. Each one has worked for no more than 8 months. The first three were replaces under three year warranty, the fourth by a factory rep and I bought the fifth today. The first three all failed with Flow Chk PCB error message. The fourth just stopped working on Sunday, no power or lights. A local Pentair warranty person, whom I paid a Service Call, unplugged the unit, opened the small power center cover, showed me the green light indicating that there was power, plugged in a new IC 40 which worked immediately (as did the other four). I asked if I should replace the power center and he said that it’s basically just a transformer and is working fine. We do get occasional power blips that make the clocks on microwaves, etc blink, but I thought that the power center essentially isolates the cell from these. I do have a Florida Power and Light surge protector on the electrical box that brings power into the house. I have now talked to the pool builder, two Pentair warranty repairmen and one factory rep. I am at a loss. They all tell me they have no idea why these units fail after less than a year. This last IC 40 was installed 3/24/2010, version 2.0 and now failed in less than 5 months. Should I replace the power center that the IC 40 plugs into. Any other suggestions. I have been told that this is the best chlorinator. I don’t want to keep replacing units. By the way, each unit had been spotless inside. I keep the water chemicals and salt levels at ideal levels. The units have never worked long enough to get dirty inside. The power center is connected to an Intellitouch control system outside with an indoor control panel. Last time I called Pentair North Carolina and got some smart alec tech person that had no suggestions. Please Help if you can.
ANSWER : I’ve had the same experiance. On my fifth one as well. Fail every year. No idea why.
Read Full Q/A … : Sport & Outdoor – Others
What does the ball joint look like – BeckArnley Suspension Ball Joint 101-5971 101-5971 Suspension Ball Joint
ANSWER : Http://ecx.images-amazon.com/images/I/31qt25LzXfL.jpg This is a pic of the ball jooint.
Read Full Q/A … : Sport & Outdoor – Others
APA 8 BALL POOL LEAGUE RULE QUESTION. ….IF 8 BALL IS SITTING ON VERY EDGE OF LEFT HAND CORNER POCKET…. THE OTHER OPPONENT SHOOTS THE 4 BALL TO THE RIGHT HAND CORNER POCKET & WHEN THE 4 BALL DROPS INTO THE RIGHT HAND POCKET THE VIBRATION FROM THE 4 BALL DROPPING CAUSED THE 8 BALL TO DROP IN THE LEFT HAND CORNER POCKET….WHAT WOULD BE THE RULING ON THIS?
ANSWER : It is an illegal shot and the player who made the 4 ball shot loses the game
Read Full Q/A … : Sport & Outdoor – Others
How to assemble a sportcraft ping pong table – Kettler Stockholm Indoor Table Tennis Ping Pong Table
ANSWER : Need direction to put together sport craft tt5000. Lost them
Read Full Q/A … : Sport & Outdoor – Others
I have a 2001 Yamaha XL700Z Waverunner. The compression on both cylinders is about 120, it starts and runs fine – dry. Won’t quite idle, but I can start it and rev it up fine (for a short period, of course). However, as soon as it gets in the water, it will barely run – it will start and sputter and you cannot get it to run more than a few seconds or rev up. Take it back out, let it dry, starts & revs fine. It is not getting any water in the casing that I can tell, its almost as if water is getting something wet through the cooling system that I cannot see?
ANSWER : Try cleaning the carbs and the fuel lines, filter
Read Full Q/A … : Sport & Outdoor – Others
