Soft Air Famas Foreign Legion AEG Electric Powered Airsoft…

Not firing ,battery is full ,fuse is ok

How to Identify and Resolve Common Issues ?

We offer a diverse range of insights on identifying and resolving common problems in sports. Our sources encompass academic articles, blog posts, and personal essays shared by seasoned athletes. :

If your battery is dead and will not take a charge you will most likely need to replace it. Check the fuse. Many AEGs have a fuse, if the fuse goes out the gun will not function. Check the motor wire connections.
Simply put, yes. An 11.1v (with comparable capacity) will increase current in an AEG vs. A 7.4v. Make sure to use a MOSFET!
On average, firing one BB out of AEG costs about one mAH of electricity. This makes the math for calculating how many shots you can expect to get out of a single charge quite simple. If you are using a 1,400 mAH battery, for example, you can expect to fire about 1,400 rounds before your battery goes dead.
The common LiPo voltage is around 3,7 volts per cell, meaning a 7,4 V battery will have 2 cells (2S), whereas an 11,1 V battery will have 3S. For most airsofters, this property only influences the way you charge the battery.
The rating tells you how long the battery can be used. For example, if the battery has a rated capacity of 1200 mAh, it is expected to shoot more than 1200 times. If the rated capacity of the battery is 3000 mAh, it can shoot more than 3000 times. If you plan to play a lot of games without charging the battery.
Should I use a LiPo battery for airsoft? May players prefer LiPo batteries because they perform better than NiMH, have more battery life for the size, and have no memory. We recommend 7.4v LiPo battery. Part of the drawback to LiPo batteries is that they can explode or catch fire if over-discharged.
As we know, in most cases, a 5V charger can be used for USB of computers and mobile phones. The charging cut-off voltage of the 3.7V battery is 4.2V and the discharge cut-off voltage is 3.0V. Therefore, when the open-circuit voltage of the battery is lower than 3.6V, it should be able to charge.
You cannot! You must somehow lower voltage from 3.7V to 1.2V.
It is estimated that one cartridge lasts about 80 shots, so it goes quite fast. The advantage of CO2 – powered airsoft guns is that they are very powerful, so if you want high muzzle velocity, you should look for your equipment among gas models.
They last forever. As long as they are not punctured you should be fine.
7.4v Batteries are one of the most common voltages in airsoft and a good all-rounder working perfectly with all most all airsoft guns.
LiPo Cell Voltage

The usable voltage range for a standard lipo battery cell is 3.2v to 4.2v. Any lower than 3.2v and the battery may be permanently damaged. Any higher than 4.2v and you significantly increase the risk of a battery bursting into flames.

What does the C rating number actually mean? The C rating number is the number of times the battery can discharge in one hour without overheating or damaging the battery.
So an 18,000 mAh phone like the Energizer could conceivably last for 50 days (in standby mode) on a single charge!
The battery will not affect the FPS of your Airsoft gun but it will most definitely increase its rate of fire. But be careful when using a higher voltage battery it may destroy the gearbox. Certain rifles take certain batteries. So be picky about what battery you choose as well.
LiPo batteries are generally safer and more environmentally friendly than other R/C batteries like NiCd and NiMH. LiPo batteries have become the most common high performance R/C battery and are used in R/C cars, boats, planes, helis, multirotors and more.
It`ll take ten hours to charge this completely dead/new battery to its full capacity. Simply just divide the mAh from the charger to the mAh of the battery! It can be left and claimed later but do keep an eye on it from time to time.
You can safely leave most batteries in your airsoft gun provided that you look after them and do not leave them entirely empty for an extended timeframe (typically no more than a couple of weeks).
This is a fairly common problem with AK-variant guns. The problem is typically either the selector switch (lever) is loose and needs to be tightened or the selector gear is not properly engaging the gearbox and selector plate. Try tightening your selector switch.

Discover Relevant Questions and Answers for Your Specific Issue

the most relevant questions and answers related to your specific issue

Slide out quit working and fuse on battery blows everytime I chan
ANSWER : Look under the coach near the slide and look for a pinched or bare wire. Sounds like you have a dead short to ground and could be difficult to find. Check the wiring to the slide motor, could be between the slide switch and the motor. Take a Volt meter and set it to Ohms. With the fuse out check to see if you get an Ohms reading between fuse wire and frame of coach. If you get a reading you have a short. Also check the power wire on the slide motor to motor case. If you get a reading the motor is shoted and needs to be replaced.Thanks for using FixyaJerry

Hi recently i both headlights not working on my gsx750f 05 model seems to me there is no power going to the fuse i checked the bulbs and are ok could it be the relay that is not functioning?
ANSWER : Check the wire no power to fuse then check wires

Spyder sonix pro paint ball gun shoots but when i shoot fast the paintballs break why and how do i fix it
ANSWER : You can read the reviews here, it may help you figure out the issue:http://www.pbreview.com/products/reviews/4233/

Have a 2004 kawasaki 3010 desiel mule that has worked fine for years with regular maint. then yesterday we started it as usual with the glow plug lights indicator and it ran for a few minutes until we went to take of and it just died. period. we tried to check thing out and finally found a bad fuse in the glow plug fuse holder, changed it with the same size and it ran the rest of the time we needed it and then again today we started and ran it same as yesterday and it worked fine for about 30 to 45 minutes and will out in the field it just quite. i immediately started searching for signs of heat or melting of wire or other signs and found none. the fuse that goes into this circuit is a 5 amp and all i had was a 20 so i said lets see what happens. it immediately blow the fuse without any out ward sign of problems.??????
ANSWER : Replace the glow plugs one or more are shorted

I bought a new mossberg 590 a1 shot gun a month ago, I love the gun but its having a couple of problems, the first problem is that when shooting every once in a while i get sprayed in the face with exuast from shooting through the safety very scary! any ideas whats causing this? how to fix it? second is that some times the fireing pin sticks and the gun will not discharge a round? the third problem is that i have had feeding issues with gun where it will not realice a gound from the tube, ive taken a tip of a knife to the stuck round in the tube and it prys out with little effort, these problems dont happen every time i go shooting, just every once in a while, but they a happening more and more, im conserned cause the gun is brand new, and i wanna be safe while shooting, can you guys help me? any ideas/solutions? please help!!!!!!!
ANSWER : Personally, with that many problems, I’d call Mossberg and get a return authorization. None of these things should be happening, especially with a new gun.

My water pump works when u test it on battery but will not work when u turn taps on it does not seem as though there is no power between fuse box and pump fuses r ok not sure what to do next
ANSWER : Go back to the water pump and test for voltage if no voltage trace wiring back to fuses sounds like broken wire.

I just put a new battery on my 2000 Yamaha G16A gas golf cart and now it won’t do anything. We have headlights that are straight wired to the battery and they work fine. I found a blown 10 amp car type fuse that was blown and straight wired around it and that didn’t fix the problem. I know it is a wiring problem because the back-up buzzer won’t even work. Is there another fuse that I should be looking for?
ANSWER : Yes, check the main fuse trace up the main cable so that you can see it. Then don’t forget to check the wire in main sw. or key.