Dear ,I have Strength master MI310X tread mill , after 5-10 of start its speed automatically increases & it trips with E1 error , can you …

I have a problem with my machine, on occasion, not recognizing when I’m starting, and the display will not start. I have to remove one of the batteries or it will stay on forever. When it starts up, it works fine, no complaints whatsoever. But lately, I’ve not been able to use it due to the start-up problem. I put the batteries in, the display comes on, but it will not start up when I begin motion. The control buttons will not work, either. Please inform me what it is I can do to fix this problem. Thank You

I have a Scuba Pro X650a regulator. After having the unit serviced this winter I used it last month for the first time in St. Croix.

The first day of diving went fine. However, as the week progressed I noticed that when taking in a breath the regulator continued to trickle air at a very small rate. While not enough to be concerned about safety at this point it has become an annoyance both from the fact that bubbles continue to trickle past my ears and air usage has increased. This is an intermittent problem.

I had it looked at by 2 certified Scuba Pro Dive shops and they could not find anything wrong with it though one did lower the first stage pressure just to a bit to see if that would work. I also cycled the control lever position for “dive” and “surface” intervals to ensure that there were no sticking problems.

It does appear that the problem is intermittent and that it only occurs when the regulator is under water.

In addition is there a diagram in which I can use to troubleshoot this problem?

NOTE: this version of the X650 was not on the recall list of Scuba Pro.

Any help would be appreciated.

Stephen

Belt just runs at max speed automatically 🙁

My 50cc mini bike starts then dies 5 secs after starting. why?

I have a 2004 60 hp yamaha 2 stroke outboard engine that doesn’t start or run well. Once warm and in the water it will idle in nuetral and also in gear. It accelerates in neutral but will die or lack power if I increase throttle while in gear. Engine will somtimes get to top speed but often while running at top speed engine will start to slow rapidly. Engine has full range of operationout when out of the water where there is no load on engine but is still difficult to cold start. Before these recent problems the engine sat up for several months and I had to change the impeller and spark plugs. Spark plugs fire, cylinders have proper pressure of 100, 100, and 110. I cleaned some fuel lines and filters and got new gas.

I have a 2008 polaris sportsman 500HD the damb thing has been nothing but problems ever since i got it, right now the damb thing won’t even run, here’s what its doing, when you start it and put it in drive and start to go it bogs down, it also leaks fuel out the bottom of the carborator; heres what i have done; i’v taken the air filter out that didn’t help, took the inline fuel filter out and by passed it that didnt help, i’v put fresh gas in it still nothing, please help

I bought a new mossberg 590 a1 shot gun a month ago, I love the gun but its having a couple of problems, the first problem is that when shooting every once in a while i get sprayed in the face with exuast from shooting through the safety very scary! any ideas whats causing this? how to fix it? second is that some times the fireing pin sticks and the gun will not discharge a round? the third problem is that i have had feeding issues with gun where it will not realice a gound from the tube, ive taken a tip of a knife to the stuck round in the tube and it prys out with little effort, these problems dont happen every time i go shooting, just every once in a while, but they a happening more and more, im conserned cause the gun is brand new, and i wanna be safe while shooting, can you guys help me? any ideas/solutions? please help!!!!!!!