Remington

Experienced athletes share their insights in answering this question:
Well, without a brand and year, it will be hard to figure out exactly. Here are some basics. First thing, peg the tent down. (At leat the corners)Next, locate the two longest poles. These are usually fit through a sleeve in the roof of the tent and attached in the corners via pegs or inserted into a pin. Put one corner in, then go to the other side and slide/bend the pole until it fits into the corner. Let it flop on the ground. Do the same for the other corner and the tent should be standing.Next, if there are other poles, they could be for the front entrance or to support the rain guard. Look for peg holes or pins to place the poles into and that should give you an idea. (Also look up your model on the internet to give you an idea how it looks.)Depending on where you are camping, you may not need the rain cover. It goes over the top and probably bungies into the peg holes.Hopefully this will get you started. good luck. Alley

How to Identify and Resolve Common Issues ?

We offer a diverse range of insights on identifying and resolving common problems in sports. Our sources encompass academic articles, blog posts, and personal essays shared by seasoned athletes. :

Peg the back down first – by pegging down the back of the tent first, even before any poles are in, you can anchor the tent, preventing it blowing away in the wind. You can then go and re-peg once you`re done. Don`t force the poles too much or they could break.
The tent-pole technique is an effective method for increasing the horizontal ridge dimension, minimizing postoperative complications, and facilitating subsequent implant placement.
Freestanding tents function just as their name implies: The tent bodies can hold their shape on their own without needing to be staked out. These designs receive their support from included tent poles and can be picked up and moved around camp without going limp.
Even though dome tents look difficult to set up alone, they are actually one of the easiest tents to assemble by yourself! If you have a newer dome tent, it is simpler than ever to put one together. However, a lost instruction manual can mean the difference between an easy task and a much more difficult one.
There are a few ways to secure your tent without stakes. For example, you can use rocks, logs, or sandbags to hold down the corners and edges of your tent. You can also use guy lines and ropes to help keep it in place. If you`re camping in a windy area, it`s a good idea to use all of these methods for extra stability.
When pitching a tent in a steady rain, if possible, assemble it under a thick canopy of tree branches, which often provides some shelter from the rain. Once it`s set up, you can move it to your preferred tentsite and stake it out.
The skeleton of the tent – the poles or air tubes. Basically, there are two main types of tent pole: Bendy ones and rigid ones. Bendy ones are more flexible and usually lighter, rigid ones are generally more robust and heavy-duty.
The bend is by design and accommodates the strong arc and steep walls and actually improves performance. If you get a slight bend, not by design, this won`t affect the overall performance of the tent so resist the urge to bend it back into shape. Bending poles back stresses the metal further and causes damage.
A broken tent pole is a painful, but relatively common camping mishap. Causes range from strong winds to poles weakened by age to cheap materials—and sometimes, it`s just plain old wear and tear.
Using a mallet or a nearby rock, take the spikes that come with your tent and hammer them into the ground. This will stabilize the tent and make sure it doesn`t move around. If you don`t have tent pegs for whatever reason, you can improve by using sturdy sticks and pushing them into the soil.
Properly staking a tent prevents it from getting blown about in windy conditions, and staking the rain fly out away from the tent`s body helps to keep water out. Learning to stake a tent correctly is an essential skill to have if you plan on going camping a lot.
Hammering tent stakes is something you need to know. It is essential to hammer tent stakes correctly to prevent them from bending and breaking. First, hit the tent stake with a quality rubber mallet, ensuring the angle is 90°, so it is firmly in the ground.
One person can set up a 12×14 wall tent in 30 minutes very easily. Two people can set up a 12×14 in around 10 minutes.
Pop-up tents are the fastest tents to set up. They`re already assembled, with all the extra-bendy poles already inside the tent sleeves, and packed into a round package. You simply need to take the pop-up tent out of the bag, and, as the name implies, it pops open.
They are a free standing tent – they don`t need to be pegged down to create a structure. Pegging a pop up tent down is essential if you want to avoid your tent blowing away under even a gentle breeze. So pop up tents do come with pegs. What`s more, it is important that you use the pegs too.
However, even for some experienced campers, we remain unaware that tents are not fully waterproof! Feeling the material, we might think that tents can repel water completely, but contrary to popular belief, tents are only water-resistant.
Most tents are designed to withstand a certain amount of wind, however speeds over 30 mph can cause damage. Remember to take rain ponchos and lots of plastic bags. Pack your clothing and bedding in plastic bags before packing into rucksacks.
Cold and oxygen-rich air is drawn in at the ground under the outer tent and through separate circulation valves located low down and ensures circulation and replacement of moist air both in the inner tent and in the layer between the inner and outer tent.
Placing a tarp under your tent extends the lifetime of your tent by protecting it from wear and tear caused by rugged terrain. Sharp rocks, sticks, or tree roots can tear or puncture the bottom of your tent. A tarp also insulates your tent, minimizes moisture, and makes it easier to clean your tent.
For most tents you should start at one end then progress to the other, pegging each side as you go. The level of tension should be equal all round, and tight enough to prevent flapping, without placing too much strain on the structure & material.
For maximum holding power it is important to place the tent stake straight into the ground. Don`t be tempted to angle the tent stake. This is because just a slight angle of the tent stake towards the tent reduces holding power a lot.
Some brands produce their own pole kits to suit their tents. But for the most part, there are all interchangeable with the only variants being the material and the adjustable lengths.
The Holland Push Pole Tent is similar to a non-framed tent with a center pole. Each push pole comes with the corners and peak reinforced with steel plating, along with webbing reinforcements sewn up the seams.
4. Pole Attachment Points – This is the point where the end of the pole is attached to the inner or outer tent body.

Discover Relevant Questions and Answers for Your Specific Issue

the most relevant questions and answers related to your specific issue

Square tent with 2 types gazebo poles, varenda, 2 side windows
ANSWER : The 2 longest of the poles go in an x over the center of the tent and the 2 shorter ones go arch to the sides. http://www.wenzelco.com/details.aspx?NavID=412shows a picture very similar to your tent. If you go to image 2 it shows it with out the fly. now if you got 2 sets of 4 poles, 2 long and 2 short, and one set is all aluminum, then I would go with the aluminum set. It is less likely to collapse in high winds.

Read Full Q/A … : Remington

Swiss Gear Tent – Broken Poles SG33071F
ANSWER : Take a look on amazon for replacement. here: Amazon com tent poles. I hope this was helpful. Cheers

Read Full Q/A … : Remington

I need new poles for Swiss Gear tent # SG33071F
ANSWER : Go to Home depot and buy a tube that fit the pole. Cut it into 5 or 6 inches for the broken areas. It costs me less than 2 dollars. Let me know how it turn out on yours.

Read Full Q/A … : Remington

How to stabalize four tent poles in an open area.
ANSWER : If you get four sturdy poles (not normal tent poles) then the best thing to do is to stake the four poles into the ground at a 60 degree angle with the top away from the tent and then use the tension created by the angle to support the tarp.

Read Full Q/A … : Remington

Ripped outwell tent
ANSWER : Log onto http://www.imagescotland.com/scottishmountaingear-home.asp
this is outwell’s recommended repairer!
Good luck
ps. putting the pins in is very tricky – needs strength and patience!

Read Full Q/A … : Remington

Tent I bought a tent the name on the outside says South Mountain.Not sure how to put up. It has two long rods & two short ones it looks like there are two rain gaurds also. There are no instrutions that came with this tent. Are there any pics that that show how to put up. I think the tent is around five years old.
ANSWER : It has to be similar to this (see link below). Most tents assemble in similar ways. Insert rods through the sleeves. Hook one side of the rod to one corner, arch the rods and hook the other side of the rod to the opposite corner. Repeat for the other rod.

http://www.coleman.com/coleman/images/pdf/2000000136.PDF

Read Full Q/A … : Remington

I have stripped the thread in an extendable tent pole.
ANSWER : If you go to any good tool store or engineering store you can get what is known as helecoil insert.just tell them the inside diam of the pole.they will probably put it in for you if yuo take the pole along.hope this will help.regards barry.

Read Full Q/A … : Remington